Sometimes juice spits n spats, into my mouth. Is that a sign I'm squoking too much or something?
Spitting
- Thread starter Steelgirl
- Start date
- th_trl_thread_readers 0
- Status
I've found my twisted or braided coils do this more so then strait coils, also my sub ohms can do this as well, only option I can think of is move up to a higher ohm coil which will give you a cooler vape, and a little less vapor, but can still be very flavorful if made correctly.
Are you using a wide bore drip tip? The bigger the bore the more juice will pop up in your mouth. Unless you have a huge air hole in your atty you don't need a wide bore.
Hmmmm, all good explanations.
Widish bore drip tip.
Coil bout 2 or 3 days of use, cotton wick new (change daily). 1.4 ohm. Strait, untwisted 30 ga. The vape is quite warm. Maybe warmer then I want actually.
I'm not perfect on my coil builds yet. Maybe less spitting when I get more experience.
Widish bore drip tip.
Coil bout 2 or 3 days of use, cotton wick new (change daily). 1.4 ohm. Strait, untwisted 30 ga. The vape is quite warm. Maybe warmer then I want actually.
I'm not perfect on my coil builds yet. Maybe less spitting when I get more experience.
I'm amazed this didn't get off track.
It was just waiting for you to get it started...
Your atty REALLY likes you....
Experiment with different drip tips. With a small bore drip tip my Cyclones were unbearable, I felt like I was drinking more than vaping. I tried a large bore strait tip and it wuss a little better, tried a large bore tip with a medium bore throat (@ the O-ring end) and the drinking was reduced to near zero even with the loud coil pop that occurs when vaping a Cyclone below .5 ohm.
I would bet switching to a heavier gauge wire (#28 or even #26) and more wraps would alleviate the issue as well. I have ordered 26&28 to test this theory.
Experiment with different drip tips. With a small bore drip tip my Cyclones were unbearable, I felt like I was drinking more than vaping. I tried a large bore strait tip and it wuss a little better, tried a large bore tip with a medium bore throat (@ the O-ring end) and the drinking was reduced to near zero even with the loud coil pop that occurs when vaping a Cyclone below .5 ohm.
I would bet switching to a heavier gauge wire (#28 or even #26) and more wraps would alleviate the issue as well. I have ordered 26&28 to test this theory.
Last edited:
She's pretty new. Don't scare her off yet.I'm amazed this didn't get off track.
You're most likely just over squonking, thats the only time I get some liquid in my mouth.
That or I get confused and take a draw as I squonk lol.
That or I get confused and take a draw as I squonk lol.
Check to make sure you don't have your wick blocking off your juice hole where the juice won't fully go back into the bottle. Sounds to me like excess juice on the deck. Also, when I was using a wide bore shorty, I for sure got juice spitting up into my mouth. I mostly use delrin tips now with a normal bore and standard length. My airflow is right, so it works and haven't had problems since, even when I do hear some juice pop from time to time.
I switched back to drip tip that came with the rm2. Big difference. No more spitting.
Nice smooth vape now
Nice smooth vape now
I switched back to drip tip that came with the rm2. Big difference. No more spitting.
Nice smooth vape now
Good! Glad you got it figured out.
A lot of people like the big bore drip tips. In reality the drip tip bore doesn't need to be any bigger than the air hole in the atty, or the sum of two holes if you have a dual coil.
- Status
Similar threads
