SS Mesh on Vivi Tank aka Hyer SRT

[Necromancer]

Did a small tryout on ss mesh on smoktech vivi tank aka Hyper SRT...

Materials used:
Kanthal A-1 32AWG
#400 SS mesh 2.5cm x 1cm
999 Silver Wire

Rolled the ss mesh with a very small needle, oxiidized the ss mesh by torch and dunk in water 3 times, need to be tight as the hole for vivi tank is pretty small. Slotted into the hole

Built the wire using igetcha69 penelope/ody method (See REVIEW OF THE ODYSSEUS REPAIRABLE ATOMISER - YouTube )

Connected the wires to the screws and coiled the kanthal wire around the ss mesh

Used a heated needle to burn a small hole of the top part of the vivi tank for air flow

Burns well and enjoying the vape now!! The extra hole i used it to needle fill my juice

 

[ussr]

Nice. But this would mean u cannot tilt the tank or the liquid will flow back to the top unless got something to plug the top hole where the wick used to be.

Looking at your coils, are you using NR for the legs to join to the poles? I doubt there is a need to?

 

[Necromancer]

dont need to, just eliminate any hot spots from the big gap in between

 

[guilt8921]

Nice. But this would mean u cannot tilt the tank or the liquid will flow back to the top unless got something to plug the top hole where the wick used to be.

Looking at your coils, are you using NR for the legs to join to the poles? I doubt there is a need to?

why would you plug the hole when the ss mesh is in there?