Starter Dripper

[blueGrassTubb]

I'm looking to get a dripping atomizer that is good for a starter. I'm not looking to build exoctic coils, but simple micro coils (for now!). I want something that is simple and works great in the 1.3Ω-1.8Ω range.

I'm looking for something that is good quality and can be built in a similar fashion to the kayfun. I want to keep things as simple as possible for now.

Thanks

 

[State O' Flux]

One of the Youde IGO-W series RDAs would be a good place to start. Simple, well made and inexpensive. Not necessarily the 'W'... just one of the 'W' series that suits your fancy.

 

[James Hart]

I'll second the IGO-W... if your eyes and fingers are good, then you can also try the IGO-S

 

[dripdaze]

I am a fan of the IGO-W too. I had no problem learning to do builds on it and it works great. The only issue is the size of the air holes. They are a little small for lung hits. They can be found on ebay with pre-drilled holes.

 

[blueGrassTubb]

Thanks.

I ordered an igo-l from ebay for a paltry $10, and then wandered by one of the local B&M vape shops and picked up an igo-w.

I'll be building that bad boy tonight.

I know that you can use a single coil in the igo-w, but want to try my luck with a dual coil.

I understand the principle behind dual coil (the Ω will be half that of a single coil of the same resistance - if I put in 2 3Ω coils, the resistance will read 1.5Ω), but I'm wondering what might be the best way to get a 1.3-1.8Ω dual coil setup with 28g kanthal.

What size wire should I be using (28g is all I have on hand) to be able to avoid having to go with as many as 18 or 20 wraps?

Thanks

 

[dripdaze]

Use this site and just fill in the blanks: Steam Engine | free calculators for your vaping endeavors

 

[Jjshbetz11]

Well I can tell you a tight(ddrill twisted)twisted 28g. wrapped around a 2mm. Six wraps, jig will net .7 ohm. Not trying to rush into twisted builds! You should go through the proccesses to find your ideal vape.