So, my stepfathers Nimbus clone came in yesterday, and I was taking a closer look and one of the posts is a little twisted. I'm almost positive I can fit kanthal through it fine, and the hole isn't like completely turned to the right/left, but it's still pretty noticeable and I'm worried it could cause a problem or something and don't want to rebuild it with the chance of it blowing up on me. Will it work fine? Will it short out? Is it safe? Should I just be careful with it? What precaution should I take? Really needing assistance on this one.
Stepdads Nimbus clone came in, a post is twisted a little, is it safe for use? Please help.
- Thread starter Frogzx
- Start date
- th_trl_thread_readers 0
- Status
My friend bought the same atomizer and if I remember correctly it came with a dual coil set up on it and it worked fine for him and I even set up a single micro coil on it. He posts were twisted worse then that. It takes some wiggling of the wires to get the coil to sit where you want. Good thing about wire is it bends where you need it to go.
U sub-ohming? If yes - i have no suggestions - if not - build it and test it......as far as i know- on a vv if it shorts it wont fire....
As long as your wire dont touch the side of the deck(Gonna be a pain as its turned toward the side)I think you'll be ok.You may be able to put a needle or something in there and twist it a bit.Im not exactly shure how these are made so twist at your own risk lol. Hope this helps
It's fine. Mine is far worse. Go ahead and build it up.
Sent from my SM-N900T using Tapatalk
Sent from my SM-N900T using Tapatalk
I think it would be fine, just make sure your wire isn't touching the sides of the base.
CASAA member 2013
Sent from my iPhone using Tapatalk - now Free
CASAA member 2013
Sent from my iPhone using Tapatalk - now Free
- Status
Similar threads
