subox nano ?'s

[Road King]

So I've had the Kangertech for a couple of weeks now (I got it as a gift) & it's my first e. I'm an old guy who is new to vaping & some of it's lingo, but I have a few questions I was hoping to get some input on.

1) It came with a .5 coil in the tank, but with a 1.5 in the box. I am using the one that came in it, but don't really know the difference?

2) If I decide to keep on with this setup I may want to upgrade to another tank, like a top-fill with a little more capacity. I worry that some may leak? What are the best ones to consider?

3) This thing dials up to 50w, but with the .5 coil in it, it's just too much. I'm finding it works best for me around 20 watts. Does anyone else have a suggested setting I may want to try?

4) As mentioned above, I received this as a gift. I didn't get to go pick it out or anything. I took it to the cigarette store my wife got it at & they were QUITE UN-knowlegable about it. All they could tell me was that it was a "good" one. Is that correct?

I've really had no issues with it & the only complaint (if you could even call it that) would be about the lack of a top fill tank.

Thank you from a true newbie!

 

[Baditude]

1) It came with a .5 coil in the tank, but with a 1.5 in the box. I am using the one that came in it, but don't really know the difference?

Lower ohm (smaller number) will burn hotter than higher ohm (higher number) and provide a "warmer vaping experience". Higher ohm (larger number) will burn cooler and provide a "cooler" vaping experience".

Lower Ohm Coils Will:

• Heat The Coil Faster
• Produce More Vapor
• Drain The Battery Faster
• Use E-Juice Faster
• Produce A Warmer Tasting Vape

Higher Ohm Coils Will:

• Heat The Coil Slower, Which Will Produce “Less” Vapor
• Provide A “Cooler” Tasting Vape
• Use Less E-Juice
• Prolong Battery Life

2) If I decide to keep on with this setup I may want to upgrade to another tank, like a top-fill with a little more capacity. I worry that some may leak? What are the best ones to consider?

All "tanks" have the potential to leak, especially with temperature changes (going from air conditioning to hot outdoor air) and air pressure changes (elevation changes). Most often leaking is due to user error.

Personally, I've decided to avoid using tanks and currently use a rebuildable drip atomizer where I make my own coils/wicks. It has eliminated any frustration that I've had with tanks, is less expensive in the long run, and allows a far more satisfying vaping experience (better flavor, more vapor, and changing flavors on a whim). Downside for some people is that you have to add more e-liquid every 10 puffs, and carry a bottle of juice with you. For me, the positives outweigh the negatives.

3) This thing dials up to 50w, but with the .5 coil in it, it's just too much. I'm finding it works best for me around 20 watts. Does anyone else have a suggested setting I may want to try?

Always start at a lower wattage setting and gradually work your way up until you find your personal "sweet spot". Different ohm coils and different flavors will possibly dictate a different power setting. Personally, I vape between 10 - 20 watts regardless of the ohm or flavor.

4) As mentioned above, I received this as a gift. I didn't get to go pick it out or anything. I took it to the cigarette store my wife got it at & they were QUITE UN-knowlegable about it. All they could tell me was that it was a "good" one. Is that correct?

Google search for the specific brand and model battery device and tank for reviews and demos of your setup.

 

[Douggro]

So I've had the Kangertech for a couple of weeks now (I got it as a gift) & it's my first e. I'm an old guy who is new to vaping & some of it's lingo, but I have a few questions I was hoping to get some input on.

1) It came with a .5 coil in the tank, but with a 1.5 in the box. I am using the one that came in it, but don't really know the difference?

2) If I decide to keep on with this setup I may want to upgrade to another tank, like a top-fill with a little more capacity. I worry that some may leak? What are the best ones to consider?

3) This thing dials up to 50w, but with the .5 coil in it, it's just too much. I'm finding it works best for me around 20 watts. Does anyone else have a suggested setting I may want to try?

4) As mentioned above, I received this as a gift. I didn't get to go pick it out or anything. I took it to the cigarette store my wife got it at & they were QUITE UN-knowlegable about it. All they could tell me was that it was a "good" one. Is that correct?

I've really had no issues with it & the only complaint (if you could even call it that) would be about the lack of a top fill tank.

Thank you from a true newbie!

First, Welcome to the ECF family! As a beginner, you're in a good place.

I'll try to answer your questions, in order:

1. Coil resistance determines how quickly the coil will heat and how hot it can get. The lower the Ω's, the more power you can apply and get more vapor and flavor. The 0.5Ω coil is not a bad one, but if you were to use the 1.5Ω coil, you would want to drop the wattage down below 9W as a starting point. Each will deliver a different vaping experience; sub-ohm coils are for those chasing maximum flavor and vapor, have more airflow (loose draw) and will make for a warmer vape. Coils over 1Ω start restricting the airflow (tighter draw) and are a cooler vape, but can be good for MTL (mouth-to-lung) vaping where the vapor is drawn and held in the mouth before fully inhaling.
2. The Nano's are somewhat small compared to other mods, so other tanks may overhang the body of the Nano box. You can put any tank you want on it though - matter of personal choice. Leakage isn't much of a concern with most tanks using stock coils these days.
3. In part, see #1. Somewhere in the 20-30 watt range is a good performing point for the 0.5Ω Kanger coils based on my experience with them. If you look at the coil, you may see a wattage range on it along with the resistance rating; the low number is a good place to start with your wattage setting, then ramp the wattage up or down to suit your taste.
4. Kanger, on the whole, makes very decent products. I have some Kanger gear myself and I'm happy with it. You didn't get an off-brand knock-off.

Don't hesitate to ask more questions! Enjoy!!

 

[Road King]

Thanks guys.
I now know WAY more than I did.

I think I'm going to like this place!

 

[Douggro]

Thanks guys.
I now know WAY more than I did.

I think I'm going to like this place!

If one can ignore some of the contentious bickering that takes place in some threads, there's Information Overload aplenty here.

 

[crxess]

If one can ignore some of the contentious bickering that takes place in some threads, there's Information Overload aplenty here.

So true!


Welcome aboard Road King!

 

[coolerat]

So I've had the Kangertech for a couple of weeks now (I got it as a gift) & it's my first e. I'm an old guy who is new to vaping & some of it's lingo, but I have a few questions I was hoping to get some input on.

1) It came with a .5 coil in the tank, but with a 1.5 in the box. I am using the one that came in it, but don't really know the difference?

2) If I decide to keep on with this setup I may want to upgrade to another tank, like a top-fill with a little more capacity. I worry that some may leak? What are the best ones to consider?

3) This thing dials up to 50w, but with the .5 coil in it, it's just too much. I'm finding it works best for me around 20 watts. Does anyone else have a suggested setting I may want to try?

4) As mentioned above, I received this as a gift. I didn't get to go pick it out or anything. I took it to the cigarette store my wife got it at & they were QUITE UN-knowlegable about it. All they could tell me was that it was a "good" one. Is that correct?

I've really had no issues with it & the only complaint (if you could even call it that) would be about the lack of a top fill tank.

Thank you from a true newbie!

In a general sense the differance between a .5 build and a 1.5 build is power. In the case of the Nano its also airflow.

The 1.5 coil has a very small air hole for a restricted draw. To farther muddy the waters they also make a 1.2 coil which is a lower power version of the .5 but with the same airflow.

Its unfortunate they can't include all three heads but its being sold pretty cheapy already so ya gotta draw a line somewhere. Also when you replace the head after a week or two you will find all stores carry the .5's but only some carry the 1.2's and 1.5's and almost none carry all three.

.5- prolly the "normal" coil. Decent airflow and power.

1.2- decent airflow and reduced power

1.5- VERY restricted airflow at a reduced power.

They also make a rebuild able coil for that line of tanks but sadly it will not fit in the Nano.

You have a great setup there. Somebody really likes you.

 

[crxess]

1.2- decent airflow and reduced power

Excellent Beginner to intermediate Vapers coil.
Good MTL to light Lung Draw.
Allows full functional use of the AFC system.

 

[Douggro]

Excellent Beginner to intermediate Vapers coil.
Good MTL to light Lung Draw.
Allows full functional use of the AFC system.

Agree. The 1.2 is my favorite stock coil for just those reasons.

 

[Road King]

Wow.
Thanks again, all.

 

[Douggro]

Wow.
Thanks again, all.

You're welcome. If any of this sailed over your head or you need expanded explanation on some of the points, ask - we'll be glad to assist.