Subtank mini rba help

[rcthompson0409]

So I got a subtank mini after hearing a lot of good things the stock coils are amazing but I can't seem to get the rba to work properly I've tried everything I can think of and it just doesn't wick properly I always have to auto drip covering the air hole and puffing on it a little and even then it doesn't taste right can someone help. I hope I have this in the right forum


Sent from my iPhone using Tapatalk

 

[Susan~S]

Try looking at this video. You don't have to use Koh Gen Do cotton but the amount of cotton (and the placement) does make a difference.

Kanger Subtank Mini RTA Build

 

[rcthompson0409]

I've done just like the video but I still have to auto drip


Sent from my iPhone using Tapatalk

 

[Susan~S]

I've done just like the video but I still have to auto drip

What is the ohm of your build?
What wattage are you running at?
That's the PG/VG of your juice?

 

[rcthompson0409]

I usually run .5 ohm build on a mech mod or on regulated mod at 25 watts with 70 vg 30 pg


Sent from my iPhone using Tapatalk

 

[AntnyMikal]

I can't get mine to work consistently either. I've built all kinds of other tanks with no problem, but this one just refuses to wick consistently. I'm going to open up the the juice wells a little and see what happens.

 

[shatteredsoul76]

Ive only built the RBA section twice in mine and this last time I went with the pancake wick and its working great so far, I ran across the method on rip trippers youtube video.

 

[AntnyMikal]

I was going to try that the next time I mess with it. I've seen the video, so I'll give it a run. Hopefully it works out.

 

[rcthompson0409]

I've tried the pancake method and I've opened the channels a lot still no luck any other tip


Sent from my iPhone using Tapatalk

 

[Susan~S]

I've tried the pancake method and I've opened the channels a lot still no luck any other tip

You could try thinning out your high VG juice with a few drops of distilled water per ml of juice.