Subtank Mini RDA Not Firing - Pin Problem? FIXED

[Off cigs]

I used 28 ga kanthal and made 1 wrap around the base of the airflow pin between pin and insulator. A bit tidier than running through the air holes.

 

[Killowatt]

I just did this and it finally worked... Wrapped a few rounds of 26g kanthal around those air holes and it did right up.... Even if I do have to fight to get it in and out of the base due to all the kanthal around the edges lol..... But it works!

Thanks, I have a sub tank mini rba giving me connection fits, this solved it perfectly. Now fires on several mods I have. I pulled the wires snug, so the wire fits nice and tight.

 

[Killowatt]

I used 28 ga kanthal and made 1 wrap around the base of the airflow pin between pin and insulator. A bit tidier than running through the air holes.

I'm thinking of making a thin washer, to replace the wrapped wire on the base.

 

[Killowatt]

I used 28 ga kanthal and made 1 wrap around the base of the airflow pin between pin and insulator. A bit tidier than running through the air holes.

Made a very thin washer for my sub tank mini rba base screw, to replace the wire wrap through the air holes. Used that thin clear plastic that covers almost every small product we buy today, drilled a 11/64 hole, slid it over the base screw, then used my kanthal side cutters to trim excess around the outside. Works like a charm, no more hassle with the kanthal scraping the sides of the base threads.