Switching from Clearos to Dripping... Nic Levels..

[jhicks3301]

Ok folks.. So my normal setup for months has been a MVP2 with either a nautilus or a 30s...
Just bought a StingRay with a Patriot RDA built at .25 ohms

Loving it.. When I bought it, tried it with a 0mg nic level just so he could show me the cloud production, etc...

Well my tanks, I'm used to vaping at a 12mg nic level.. I know I have to drop it down for dripping...

So I bought a 6mg juice and I can't hit it dripping.. to harsh.. So my question is, will a 3mg make that big of a difference or should I raise up my ohms?

Thanks!!

 

[Maurice Pudlo]

Try going with 0.6 ohms, if that isn't doing it for you cut the nicotine level to 3mg/ml.

But yeah start with resistance adjustment, if you can get a quality vape in the 0.5 - 0.6 ohm range you should be set.

If you find that you simply prefer the lower ohm coil set up, by all means drop the nicotine content as much as you need to.

Maurice

 

[jhicks3301]

Try going with 0.6 ohms, if that isn't doing it for you cut the nicotine level to 3mg/ml.

But yeah start with resistance adjustment, if you can get a quality vape in the 0.5 - 0.6 ohm range you should be set.

If you find that you simply prefer the lower ohm coil set up, by all means drop the nicotine content as much as you need to.

Maurice

Thanks for the quick reply.. When i tested it with 0mg, I loved the flavor, the heat, and cloud production.. I just don't know if dropping down to a 3mg Nic level will do much of a difference..
I mean, I can hit it but I cough.. I rather it be much more smoother..

 

[Maurice Pudlo]

I vape 6mg/ml now, on the same device hitting 12mg/ml is hell.

In my experience cutting the nicotine content in half does make a big impact.

Maurice