T3's not seating all the way on ego?

[Sqhertz1]

a couple of my t3's wont seat all the way on a couple of my smok ego batts. they almost thread all the way down then just stop making it not fire with the battery. they do thread on my vision spinner 1300 and smok 450 and work fine.

i tried a couple different bases but get the same result. my evod on the other hand will thread just fine on all of them.

any reason they would do this?

i know the simple remedy would be to replace them all with evods (which im slowly working on), but i would like what i have to work.

 

[crxess]

All the way is not the issue. All the way equals getting the 2 devices stuck together and having a fit getting them back apart.

MAGIC WORD is T3

Look up inside the T3
The T3 pin is Flat and gives a lot of trouble on some mods and on batteries where the center pin has been compressed.
1) gently raise the battery center pin with a small screw driver or paper clip with the very end bent a bit.
2) SLIGHTLY pull the T3 pin outward(VERY SLIGHTLY)

Any time you go for Tighten fully, you increase damage to your devices. Snug To Contact.

 

[Unforeseen]

Moved to Assorted PV Topics - Clearomizers

 

[SASmith]

Hi here is a link to PBusardo's video tutorial on how to pull your post,
A PBusardo Tutorial - How to Pull Your Post ;-) - YouTube

 

[Donovan69]

Face it the threads on t3s are always crunchy when you first thread them down on an ego battery. Likes been said don't over tighten. You may have pushed your post down in your batt or your t3. Watch the vid and try pulling the post. You just need to make a connection. Are they actual T3s by kanger? Do they say Tabac on them? I have never had any issues with connections on the T3s myself and think they and the evods are awesome beginner vaping products!