Purchased a Fogger v1. Gave it a little needed attention, and it seemed to work fantastic.
Problem I can't figure out is it leaks when the juice level goes low. If it filled up, it holds its pressure and doesn't leak....and I must say delivers a fantastic vape imho. Huge plumes of vapor! Great taste too...better with cotton vs ss mesh.
Anyway, I'm a little lost because I don't understand how the tank pressurizes itself and what is causing the loss of pressure.
The silicone o rings are clear not black. Very thin, and easily break!
the black ones available at home depot (hardware store) seem to be way too thick for this application.
So to recap, full of juice, I'm able to vape for a while, no leaks. When the juice gets to low, it floods the chamber and leaks out of the center 510 connector pin which is also it's air flow intake.
Any advice? Maybe where I might find the proper small thin rubber/silicone o rings...? Or something I can do to test or repair? I'm a little lost.
Many thanks in advance!
Sent using my typewriter
Problem I can't figure out is it leaks when the juice level goes low. If it filled up, it holds its pressure and doesn't leak....and I must say delivers a fantastic vape imho. Huge plumes of vapor! Great taste too...better with cotton vs ss mesh.
Anyway, I'm a little lost because I don't understand how the tank pressurizes itself and what is causing the loss of pressure.
The silicone o rings are clear not black. Very thin, and easily break!
the black ones available at home depot (hardware store) seem to be way too thick for this application.So to recap, full of juice, I'm able to vape for a while, no leaks. When the juice gets to low, it floods the chamber and leaks out of the center 510 connector pin which is also it's air flow intake.
Any advice? Maybe where I might find the proper small thin rubber/silicone o rings...? Or something I can do to test or repair? I'm a little lost.
Many thanks in advance!
Sent using my typewriter
Last edited:
