the title says it all.anyone else using this?just here to share the problems i had and how i solved it.
got my clone for quite sometime and been going around lately and seeing ppl having problems with it,and so did I.
most common problems with the taifun gt:
a)horrible vape the next day or burnt vapor/cotton taste.this in normally caused when the chimney is twisted during screwing the top on where the wick will be in contact with the walls causing the chimney to turn.thus causing the wick to be misalligned.also,loose on the bottom of the chimney caused by O rings.
leaking/gurgle issues.also normally caused by bad O rings at the base of the chimney.
so after a while of changing o rings and figuring out what went wrong,i seriously lost a lot of juice with the leaking going on.i keep having gurles and it keeps leaking bottom to top.the solution
LASTIC TAPE.yes gentlemen,those white flexible plastic tape which is used in plumbing to screw in pipings.
how i did it.
i removed the O ring that holds my chimney to base.
i looped the tape once tightly with no extras around the base where the o rings would fit in.try not to do more that one loop as it will be too tight and chimney wont fit in.
put back the O ring,and put your chimney in place.u will notice its almost impossible for the chimney to even turn.
this solved my problem i had once and for all,no leaks and bad taste and no more paranoia on the chimney turns.i hope this tip helps
got my clone for quite sometime and been going around lately and seeing ppl having problems with it,and so did I.
most common problems with the taifun gt:
a)horrible vape the next day or burnt vapor/cotton taste.this in normally caused when the chimney is twisted during screwing the top on where the wick will be in contact with the walls causing the chimney to turn.thus causing the wick to be misalligned.also,loose on the bottom of the chimney caused by O rings.
leaking/gurgle issues.also normally caused by bad O rings at the base of the chimney.
so after a while of changing o rings and figuring out what went wrong,i seriously lost a lot of juice with the leaking going on.i keep having gurles and it keeps leaking bottom to top.the solution
LASTIC TAPE.yes gentlemen,those white flexible plastic tape which is used in plumbing to screw in pipings.how i did it.
i removed the O ring that holds my chimney to base.
i looped the tape once tightly with no extras around the base where the o rings would fit in.try not to do more that one loop as it will be too tight and chimney wont fit in.
put back the O ring,and put your chimney in place.u will notice its almost impossible for the chimney to even turn.
this solved my problem i had once and for all,no leaks and bad taste and no more paranoia on the chimney turns.i hope this tip helps
