Hello again..
Just when I thought I had it down, things are going pear. Busy reading the "Tips & Tricks" section while I post this.
My Mini started leaking, and on closer inspection I found a tear at the top of the tube (between the bottle cap and where the tube connects at the top).
I saw Rhapsodies Fire's explanation to "Gently pull the tube straight down....should come off relatively easy. To put one on, use your ejuice as a lubricant, and slowly twist the new tube on as if you were finger tightening a screw. Takes a minute or two....and you may need to set it down, walk away & take a breath once before you get it back on. ".
I have a feeling this might take me a few days
. Is it possible to vape without a bottle by just dripping small amounts into the reservoir? I haven't vaped in a few days without any craving so it's not a dire situation or anything.
Also how do I test the health of my atomizer? I was using a Cisco 2.0 ohm 510 atty before I discovered the tube tear. I would blow it clean and then drip 7-10 drops directly on it and wait a bit. Then when I took a hit the vapour was very harsh on my throat and not much vapour production when I exhaled, but no burnt taste. Blowing it clean again and then hitting would give that burnt taste.
Lastly, I tried a LR atty (both 1.8 and 1.5) and it was really harsh on my throat. But it wasn't how I expected TH to be. It was more a coughy TH, hard to explain. Could the "feeling" of the TH differ depending on the juice used? Bear in mind I am using 100% VG so maybe my body doesn't agree with it or something.
Just when I thought I had it down, things are going pear. Busy reading the "Tips & Tricks" section while I post this.
My Mini started leaking, and on closer inspection I found a tear at the top of the tube (between the bottle cap and where the tube connects at the top).
I saw Rhapsodies Fire's explanation to "Gently pull the tube straight down....should come off relatively easy. To put one on, use your ejuice as a lubricant, and slowly twist the new tube on as if you were finger tightening a screw. Takes a minute or two....and you may need to set it down, walk away & take a breath once before you get it back on. ".
I have a feeling this might take me a few days
Also how do I test the health of my atomizer? I was using a Cisco 2.0 ohm 510 atty before I discovered the tube tear. I would blow it clean and then drip 7-10 drops directly on it and wait a bit. Then when I took a hit the vapour was very harsh on my throat and not much vapour production when I exhaled, but no burnt taste. Blowing it clean again and then hitting would give that burnt taste.
Lastly, I tried a LR atty (both 1.8 and 1.5) and it was really harsh on my throat. But it wasn't how I expected TH to be. It was more a coughy TH, hard to explain. Could the "feeling" of the TH differ depending on the juice used? Bear in mind I am using 100% VG so maybe my body doesn't agree with it or something.
Last edited: