temp control question

[Dom]

New to making coils with titanium and stainless steel. Im using a kanger toptank mini. 6 wraps stainless gets me to .61 ohm. Im getting huge massive hits at temps of 120 to 150. Doesnt seem right since it goes up to 600 degrees. I do have it set to the SS setting. Titanium didnt work out so well tasted real bad at first and gave me massive hits, coil gave foul hits after 3 days. 5 wraps got me to .22 ohms. What im wondering is what temp do you vape at and and does 120 degrees seem really low? Also I now use twice as much juice than kanthal. good thing i make my own flavorless juice .

Thanks.

 

[Romenov]

I'm feeling good on around 200 with my rx200 and crown when on TC, no need to wonder which is best, you can try many levels to find out the best for ya, IMO

 

[edyle]

New to making coils with titanium and stainless steel. Im using a kanger toptank mini. 6 wraps stainless gets me to .61 ohm. Im getting huge massive hits at temps of 120 to 150. Doesnt seem right since it goes up to 600 degrees. I do have it set to the SS setting. Titanium didnt work out so well tasted real bad at first and gave me massive hits, coil gave foul hits after 3 days. 5 wraps got me to .22 ohms. What im wondering is what temp do you vape at and and does 120 degrees seem really low? Also I now use twice as much juice than kanthal. good thing i make my own flavorless juice .

Thanks.

use www.steam-engine.org
and make sure you know whether your device is showing celcius or farenheit.

 

[kbeam418]

Honestly SS is not that great of wire to do temp control with. It's tcr curve is so small so any conductivity issues cause huge problems, where as ti and ni200 is less of an issue with conductivity problems.

 

[Paul lamb]

Ss is my favourite wire for TC
Then nickel

Can't stand titanium can't tell you why