Temp control with SS fused Claptons?

[eLCruz]

Hello everybody,
I have just got a roll of 2x24/32 SS fused Clapton wire hoping to use it for temp control on my RX200S with a smok TFV8 & rba section. It ohmed out at 0.17 with dual coils, tried spaced and also touching. But it just keeps jumping back to VW.
When I use just 24g SS wire, it works fine. So, I guess I want to know if SS Claptons can be used for temp control?
Thanks in advance for any and all help.
[emoji22] [emoji29] [emoji36] [emoji37]

Shiver me timbers!

 

[Boodaddy]

What's your temp in TC? Try 450° F or above, and post back. Do you have the latest firmware? I have seen other people fix this by flashing original, and then re-flashing the latest version. These rx200's don't seem to like anything under 0.30ohms. TC should work just fine with that setup.

 

[hertigg]

My RX has trouble with stainless steel under .3 ohms as well.

 

[eLCruz]

What's your temp in TC? Try 450° F or above, and post back. Do you have the latest firmware? I have seen other people fix this by flashing original, and then re-flashing the latest version. These rx200's don't seem to like anything under 0.30ohms. TC should work just fine with that setup.

I was on 420° will try 450° and reflash and let you know. Thanks.

Shiver me timbers!

 

[eLCruz]

My RX has trouble with stainless steel under .3 ohms as well.

That would be a huge set of coils on a dual coil set up... Don't have that much room. [emoji12] May try a single to see if it's possible...

Shiver me timbers!

 

[Lord Vaako]

I run SS dual fused claptons using TC on a DNA200, but on any other mod it won't work. I've always had to go to VW when i use SS.