Hey Vapers! well today I experienced a little bit of an upset... 
I was vaping on my tesla invader 2 wooden box mod and decided it was time to re wick my rda, ( i've been running a dual parallel 22 4/8 wraps with a1 kanthal ) on a haze. I know this build is pretty low lohms but not sure exactly where its at. and i hadnt had any problems with this build on this device untill today. I was re wicking it and i was pulse firing as the dual parralel gets really hot really fast. to check if the coils were burning evenly. i set the box down to let the coils cool for a few minutes and when i went to go re wick it and fire it, it wouldnt fire. so i screwed on several different rda's with several different builds ( plume veil with a dual 22 5 wrap, plume veil with single coil 20g 5 wrap and a dark horse with a dual coil 24 g 5 wrap ) none of which would fire on my device. now ive had no problems with this device at all up untill today. i looked at all the connections and everything seems fine, maybe its something inside the button? not sure... So then i figured, all my builds are too low in ohms ( i didnt have an ohm meter ) but my friend had assured me that it would have fired with the other builds and thats true because i have used both plume veils on it before without problems. so what im assuming now is that i have some how fried the mosfets and its no longer allowing the device to work? because the same thing happened to my friends IPV and he just took out the chip and re soldered it and turned it into an unregulated device. any tips/ ideas / suggestions would be great fam! I still consider myself a begginer and still have alot to learn. Figured it would be best to join the online world
I was vaping on my tesla invader 2 wooden box mod and decided it was time to re wick my rda, ( i've been running a dual parallel 22 4/8 wraps with a1 kanthal ) on a haze. I know this build is pretty low lohms but not sure exactly where its at. and i hadnt had any problems with this build on this device untill today. I was re wicking it and i was pulse firing as the dual parralel gets really hot really fast. to check if the coils were burning evenly. i set the box down to let the coils cool for a few minutes and when i went to go re wick it and fire it, it wouldnt fire. so i screwed on several different rda's with several different builds ( plume veil with a dual 22 5 wrap, plume veil with single coil 20g 5 wrap and a dark horse with a dual coil 24 g 5 wrap ) none of which would fire on my device. now ive had no problems with this device at all up untill today. i looked at all the connections and everything seems fine, maybe its something inside the button? not sure... So then i figured, all my builds are too low in ohms ( i didnt have an ohm meter ) but my friend had assured me that it would have fired with the other builds and thats true because i have used both plume veils on it before without problems. so what im assuming now is that i have some how fried the mosfets and its no longer allowing the device to work? because the same thing happened to my friends IPV and he just took out the chip and re soldered it and turned it into an unregulated device. any tips/ ideas / suggestions would be great fam! I still consider myself a begginer and still have alot to learn. Figured it would be best to join the online world 
