TFV12 ohm

[Marcel K]

hey just got a new coil for the prince tank prince-Q4 0.4ohms quadruple coil
and i have a koopor primus mod what ohms do i need to set it to its .15 by default and when i go to change it its 4 digits example - OHM { 0.000 ohms} do i set it to OHM { 0.400 ohms}

update : its says on the box 0.4ohms pre installed

but on the coil it says 0.15

 

[sonicbomb]

A coil has a resistance which in turn will require a specific balance of amps and volts. The chip detects the resistance and calculates these values based on the wattage you select.
I have heard of a device that allows you to manually virtually "adjust" the resistance, but I cannot think of any reason why you would want to do this.
I'm not intimate with the controls on your mod, but I would say that it was highly advisable to use the resistance that it detects as the true resistance of the coil and not change it.

 

[Marcel K]

A coil has a resistance which in turn will require a specific balance of amps and volts. The chip detects the resistance and calculates these values based on the wattage you select.
I have heard of a device that allows you to manually virtually "adjust" the resistance, but I cannot think of any reason why you would want to do this.
I'm not intimate with the controls on your mod, but I would say that it was highly advisable to use the resistance that it detects as the true resistance of the coil and not change it.

ok thanks

 

[Marcel K]

A coil has a resistance which in turn will require a specific balance of amps and volts. The chip detects the resistance and calculates these values based on the wattage you select.
I have heard of a device that allows you to manually virtually "adjust" the resistance, but I cannot think of any reason why you would want to do this.
I'm not intimate with the controls on your mod, but I would say that it was highly advisable to use the resistance that it detects as the true resistance of the coil and not change it.

and one more question what do i set the type to i know its khantol but my mod allows only
TC-SS
TC-NI
TC-TI
and what tcr

 

[sonicbomb]

For Kanthal use power mode.

These are all materials to use in temperature control mode
SS - Stainless Steel
NI - Nickel 200
TI - Titanium

TCR - Temperature coefficient of resistance.
This is a way to manually tweak the TC settings for the above materials