I'm using a ipv2 with tfv4 tank. Single coil works fine. But the 2 others shows check atomizer issue. Is there anyone out there that experience the same issue?
Tfv4 triple & quad check atomizer issue
- Thread starter Stormycloud
- Start date
- th_trl_thread_readers 0
- Status
You could try adjusting the firing pin. Sometimes it gets pushed down and doesnt make connection with the atomizer. Did you drop it or something?
It's brand new when I tried. I opened up the bottom and there are loose coils. Must be touching the connector cap?
not too sure myself as i bought the package and it comes with tank TFQ4 and TFT3. While the single coil tank works but when i attach the quad or triple coil, my watts and ohms cannot be read by my ipv4 d2. so in other words it wont work on my d2?
It's either not making contact, or you have a bad coil. Try cleaning the 510 on the m8d, and make sure your coil is making contact with the base pin when installed. Welcome to the board.
sounds like you are just trying to use coils are are below the ohms range of the mod.
The mod will only fire to .2 in power mode I believe so you should be just okay
However the tfv4 is a pain for making contact sometimes just take it apart and reinstall everything super tight
However the tfv4 is a pain for making contact sometimes just take it apart and reinstall everything super tight
well my bottom part is stuck onto the ipv d2 . its quite hard to remove the 510 connector so I assume it's already super tight. must i use joule mode or I can stay in power mode ?. I did open up the coils inside the quad and triple I probably mess them up. the coils shd be attached to the top right. but I still get no reading from my ipvd2.
Unfortunately the IPV2 wont fire below .2 ohm coils so you will need to get some of the .2 ohm triple coils.
- Status
Similar threads
