~The Billet BoX~

[Crocky]

This thing is performing like a champ with just one punched hole 50/50 grants vanilla custard with a 1.7ohm single coil. Very impressed with this and it hasn't even been 24hrs yet. I can't wait for my second one to come in June and extra tanks.

What did you use to punch that?

 

[bk78]

Now that's a hole!

Sent from my SPH-L710 using Tapatalk 2

Kir fanis carto punch buddy works like a dream

 

[bk78]

What did you use to punch that?

^^^^^^^^^^^^

 

[finagle69]

Okay. I'll do everyone here a favor regarding Boge SR Cartos. I was going to keep this to myself, but then I'd feel bad about it.

Laser cut, with a 2.3 to 2.5mm hole, and they wick incredibly awesome. I disturb the visible material with a needle a couple of times for thicker juices. Helps ensure it wicks like a madman.

Can be bought here in a 5-pack with a free bottle of juice:

Boge 510 3.0 Pre Punched Stainless Cartomizer 5 Pack - 1 Hole

Or here in singles for a higher price. Why you'd want to do so, I'm not sure.

ElectronicStix.Com · Single Boge 510 Blank Laser Punched Cartomizer For Tank Systems

The hole is a tad higher up than I'd like, but it's tough to complain when it's a perfectly cut hole.

 

[retird]

Yep they are great carto's...been using them for a while now.....last batch I bought in a co-op was 50 carto's shipped to my house @ 76 cents a piece ($ 3.80 for box of 5).........

Okay. I'll do everyone here a favor regarding Boge SR Cartos. I was going to keep this to myself, but then I'd feel bad about it.

Laser cut, with a 2.3 to 2.5mm hole, and they wick incredibly awesome. I disturb the visible material with a needle a couple of times for thicker juices. Helps ensure it wicks like a madman.

Can be bought here in a 5-pack with a free bottle of juice:

Boge 510 3.0 Pre Punched Stainless Cartomizer 5 Pack - 1 Hole

Or here in singles for a higher price. Why you'd want to do so, I'm not sure.

ElectronicStix.Com · Single Boge 510 Blank Laser Punched Cartomizer For Tank Systems

The hole is a tad higher up than I'd like, but it's tough to complain when it's a perfectly cut hole.

 

[Madriz]

Yep they are great carto's...been using them for a while now.....last batch I bought in a co-op was 50 carto's shipped to my house @ 76 cents a piece ($ 3.80 for box of 5).........

Can't beat that co-op price!

Sent from my Galaxy SIII using Tapatalk II

 

[Absintheur]

I did not have any leaks in mien while it was sitting in the box, however I think using a pipe cutter which slightly curved the cut end inward caused it to not have a connection with the brass ring. . So I never got to try

I really wish the Ravens had worked better for everyone. I am thrilled with the 4 I have in service right now.

 

[retird]

Yeppers....you(and a couple other folks) may have all the good ones....the ones I tried were "yuck"....

I really wish the Ravens had worked better for everyone. I am thrilled with the 4 I have in service right now.

 

[bk78]

For some reason I thought this thing was supposed to cut out when the battery's were low? I just pulled them out to test them and 1 was at 2.5v and the other was 3.2v.

 

[mwdenko]

For some reason I thought this thing was supposed to cut out when the battery's were low? I just pulled them out to test them and 1 was at 2.5v and the other was 3.2v.

What type of batteries are you using... The black AW's shut down on their own. I don't believe... Someone correct me if I'm wrong...That the BB does it on its own.

 

[Hokus]

When my batteries die, it just stops vaping ... I've never checked the battery voltage when it dies though. Ill do that next time and let you know what they are at

 

[bk78]

What type of batteries are you using... The black AW's shut down on their own. I don't believe... Someone correct me if I'm wrong...That the BB does it on its own.

I'm using the red AW

 

[Madriz]

I'm using the red AW

If I'm not mistaken the red AW's are not protected and the black are I believe that is why DD recommends them. I'm sure someone can chime in on the chemistry make up and other differences.

Sent from my Galaxy SIII using Tapatalk II

 

[Darthpistachio]

AW IMR batteries do not need a protection circuit as individually they can safely discharge up to 10 A without suffering thermal runaway - which is why they're preferred for mods that allow high wattage vaping..

Normal batteries need a protection circuit that prevents them from suffering thermal runaway when the current draw becomes too large.

Either type should work fine in the BB

 

[Mrephunk]

AW IMR batteries do not need a protection circuit as individually they can safely discharge up to 10 A without suffering thermal runaway - which is why they're preferred for mods that allow high wattage vaping..

Normal batteries need a protection circuit that prevents them from suffering thermal runaway when the current draw becomes too large.

Either type should work fine in the BB

They will both work but the red ones will drain themselves very low, lower than recommended. Where as the black protected ones will cut themselves off after dropping to a certain voltage(I believe 3.4 volts is its cutoff) so just keep an eye on your voltage with the red ones till you get an idea of how long they will last before needing to recharge. Then you can just go by a time frame for when you need to swap batts

《Sent from my handheld information procuring fruit ninja》

 

[bk78]

They will both work but the red ones will drain themselves very low, lower than recommended. Where as the black protected ones will cut themselves off after dropping to a certain voltage(I believe 3.4 volts is its cutoff) so just keep an eye on your voltage with the red ones till you get an idea of how long they will last before needing to recharge. Then you can just go by a time frame for when you need to swap batts

《Sent from my handheld information procuring fruit ninja》

That's the answer I'm looking for thank you

 

[bk78]

They will both work but the red ones will drain themselves very low, lower than recommended. Where as the black protected ones will cut themselves off after dropping to a certain voltage(I believe 3.4 volts is its cutoff) so just keep an eye on your voltage with the red ones till you get an idea of how long they will last before needing to recharge. Then you can just go by a time frame for when you need to swap batts

《Sent from my handheld information procuring fruit ninja》

Would these work https://www.canvape.com/product-p/tf16340.htm

 

[SilentEcho13]

Ah man. My 3 day old carto was kicking fine yesterday, and now it's burning.

Got a question though:

I use 75/25 juice but I punch (well, lately) 4 holes in the bottom of my cartomizer with the Supco line tap valve (Bullet punch)

The holes are much smaller than those from my Siam punch, but it doesn't deform anything.

I get zero gurgling, no juice in my mouth, nothing. 3ohms at 4.5-4.75v. I find myself having to push on the face of the tank often (the past 2 cartos).

I prime each one with about 1.2ml of juice using the condom method and most of it gets absorbed too.

Could too many holes, 4 in this case, reduce the lifespan of a carto even if it isn't flooding? Mine's tasting pretty dry.

 

[mwdenko]

Would these work https://www.canvape.com/product-p/tf16340.htm

NO..

This one...

Batteries : AW icr 123 16340 protected battery

 

[bk78]

NO..

This one...

Batteries : AW icr 123 16340 protected battery

Reason I'm asking is because I'm in Canada a nobody carries the black AW and I don't really feel like paying $25 to ship a few battery's. so the trust fire ones I linked won't work at all?