Yes maybe, I don't know lol, the anodizing kills the conductivity and it would be a pain to mask off the post of the switch, the lock rings I plan on doing
- Status
Yes maybe, I don't know lol, the anodizing kills the conductivity and it would be a pain to mask off the post of the switch, the lock rings I plan on doing
Even the lock ring would be awesome. I'm in for one of those. That would actually be better then the entire switch. You would have aluminum, green, aluminum, green tube, a small aluminum ring between tank and bottom tube, and then green tank cover again. Would look great alternating like that.
I'm going to try to polish out the top cap as well. Figure if I really mess it up I can always buy another one from you when your site goes live. Should polish out well though.
I'm going to try to polish out the top cap as well. Figure if I really mess it up I can always buy another one from you when your site goes live. Should polish out well though.
I am new at the forum and pretty much computer illiterate,but have been looking at the I hybrid on your site for the last week or so looks great and been checking in everyday for availability. However what is a pm and how is it done???
Schneck,
You have a private message inbox, much like email that you can send to forum members.
If you click faceless's name next to one of his posts it will give you a drop down and you can opt to private message him. It's much like sending an email but inside the forum.
You can later go and check your inbox by clicking notifcations at the top of the forum screen and selecting inbox.
You have a private message inbox, much like email that you can send to forum members.
If you click faceless's name next to one of his posts it will give you a drop down and you can opt to private message him. It's much like sending an email but inside the forum.
You can later go and check your inbox by clicking notifcations at the top of the forum screen and selecting inbox.
Faceless, while I am sure this is somewhere in the thread, tho damned if I have found it yet. How much are the colored tube parts?
Indeed he is. I wrapped again 4/3 pulled wick closer to the + post seems to be working better much more vapor I still think I'm over wicking. Going to try a new coil in the am.
Face I think you could use nail polish or rubber cement as masking. Then after anodizing use acetone to remove nail polish.
Ano is very delicate, acetone would likely strip or damage the ano finish. Best way to clean ano is a mild detergent (not dawn) and warm water and dry with a very soft towel by blotting. If you think chrome is easily scratched, ano is 10x easier.....take care of your ano.....
You may be right, I am just very cautious with ano. I have seen buddies who strap on a piece of black ano onto their bikes and have it turn purple in just a few months because they thought it was just another spot to wash/treat with some chemical cleaner.
$100 for the set or buy 2 for $150
The site is almost done I'm working on it all night until its done lol
Give this a go.....remove your tank sleeve so you can see your juice and when you go to vape only tilt till you see the top of your wick inside the tank just get in the juice. If you have a high PG juice then it will travel much faster through your wick than a 50% or higher VG juice. If you are using a high PG juice then definitely pinch the top of your wick or train yourself to not over tip. I think your close to being where you want to be....good luck bro.
$100 for the set or buy 2 for $150
Thanks Faceless
- Status
Similar threads
- Locked
