We have no plans of doing either material. We wont make any tips out of delrin anymore as they can release formaldehyde under heat. Not huge amounts but enough to where I find it a risk. If I wouldn't put it in my mouth I wouldn't expect customers to.
The BF Odins should be on the site in a hour, 6pm PST.
I just put in my order, along with one of the .45 drip tips. I was thinking of a Zenith 2.5, but I think this is going to turn out better. I'm looking forward to firing it up
Pin in vice, u cutting wheel on a dremel do two grooves, much faster raise and more juice delivery.
We have no plans of doing either material. We wont make any tips out of delrin anymore as they can release formaldehyde under heat. Not huge amounts but enough to where I find it a risk. If I wouldn't put it in my mouth I wouldn't expect customers to.
The BF Odins should be on the site in a hour, 6pm PST.
Craig, I find this very interesting about the delrin. If you have concerns about the gas release in a drip tip then I would say it very well could be an issue with the very popular atty that uses a delrin insert in the top cap? Maybe more so than in a drip tip??Everyone has a right to their own opinion. I don't think mine is over the top, its responsible business.
You may want to research that again. Delrin has a melting point of 347 degrees fahrenheit and the release starts well before 800 degrees, per the data safety sheets my injection molder showed me.
As for internat temps at the coil, I have personally seen them exceed 800 with a laser thermometer. Due to that is also why we wont use copper posts. We figure people like their central nervous system the way it is.
Sent from my SCH-I605 using Tapatalk
On a lighter note do you have any plans for a smaller diameter Rda similar to a cyclone size? Something 15mm or less?
I received a shipping notice so you're prolly all good. I had sent an email about adding a .45 drip tip to my order but oh well. Vape mail!
