the smoktech natural hybrid

[rogergendron1]

Here it is. . . A combo of the smoktech natural and the agi genisis atomizer. Made into a hybrid
18650


18350


pics of mods i did


as you can see the positive post on the 510 conector for the agi contacts the positive button on the battery directly and my agi has been modded so there is no spring positive. It has a solid brass post running up the center for the positive conector. almost no voltage drop here lol

works. . . Like a boss

i personally love the smooth sleek look and the square edging make for a plain but very nice mod

next i am going to polish it to a mirror Finnish. . . Back to the basement lol

 

[rogergendron1]

Sorry about the picture quality I am uSing my note pad. Before I polish the mod I'm going to check it up in my lathe and remove about a few 1000ths of an inch from the entire outside surface of the mod . This will clean up and geT rid of all The connecTing lines were the mod group TogeTher. Then I'm going To polish iT To a mirror finish. Hopefully after tHat you will barely be able to see any of the lines were the separate tube pieces connect.

Then I Think I will be happy

the best part of doing this mod is that shrinks your device by a half an inch or more by completely removing the top cap and sinking the atty directly onto the modd tube.

Now I have No voltage drop whatsoever from the positive post to the coil as my agi has a solid brass pin conector. And very little if Any voltAge drop through the body of the mod as I have modified the natural by sanding all the connectors and pins down to the shiny brass that it should be

 

[rogergendron1]

Hopfully a better pic.


the agi has been modded also to work a lot better as a geny. I have drilled out the wick hole to 3.2mm and air hole to .76 or around 2mm and fixex the spring issue. Of course now it canter be used as a dripper but as a genny it rocks with the improvments. Especially because it has the lip inside like a dripper does. I like that feature in geny mode a lot