These might interest some people...

[MattBott]

I saw a post where someone was kidding around, saying they wanted a light saber mod. Someone else posted this link: The Custom Saber Shop

I though, "Holy sh..! This is great!" After some digging around, I found that the hilt main bodies HUGE: 7" long with a 1.5" outer diameter. But, some of the extensions are closer to what a modder would use (and some of the chokes would look really rad as a mod too!). Add a pommel and insert on each end and you are pretty darn close to a finished mod body!

The REALLY cool part is the "Modular Hilt System Saber Builder" See what it will look like and what you will need before you order!

 

[Los Marauder]

So my kids love Star Wars, and as I understand, the jedi guys make their own light sabers. What if they made one of these and get them mixed up? I don't know what the volts would be but it would be a hot vape.

 

[MattBott]

Haha, thanks, I had a good chuckle with that!

By the way, they'll even do custom powder coating and drilling ; ]

 

[TomCatt]

So my kids love Star Wars, and as I understand, the jedi guys make their own light sabers. What if they made one of these and get them mixed up? I don't know what the volts would be but it would be a hot vape.

This would be how old Jedi die

 

[Skyway]

Hah, I have been on this site all morning because of you. I have pieced together a complete 4 inch ecig mod for about $70. Tube, caps, acrylic spacers to hold an 18650 and dna chip inside of it with a green LED anti vandal switch. I would order it right now if the tube diameter wasn't so thick. The inner diameter is a freakin inch and a quarter. They did a good job on the battery spacers and I understand why the tubes are so big for this purpose but it is just a bit large for an ecig. Would look pretty damn cool though.

 

[MattBott]

Damn, that's just shy of fitting a 3200 6000mah battery =\

Battery OD = 32mm (D sized)
Tube ID = 31.75mm