This is for those who own a Z-Atty Pro and annoyed with the gray colored skirt/cap that doesn't match up..

[maf2k8]

It may just be me but i was always annoyed with the skirt/cap area of the ZAP being gray in color and not matching the stainless steel color of the rest of the ZAP or the Provari for that matter.....





So i got bored, Unscrewed the skirting area ( though i am sure you can do this without removing that area ) and placed it in my drill and just ran some sandpaper across it with my drill on high and BAM!




Now it matches!

 

[Cyrus Vap]

Nice work! How did you get that thing in your drill?

 

[maf2k8]

Well i loosened up the glue that holds the skirt onto the ZAP ( pictures below ) even a strong twist and the glue will loosen up and the skirt ( as i call it ) will come loose and it unscrews off.



I then just take a bolt and washer, put it thru the hole in the skirt and pop it into my drill chuck. It actually makes the Z-Atty Pro more versatile and able to use in other devices, but the device its used on must have a adjustable or floating center pin.

You can actually use that skirt as a type of a Hippo cap but the only problem is, Your attached rba/rda/Carto/Etc needs to have long 510 threads because when you screw on the skirt to the threads, It sometimes wont allow it to reach and make contact with attached device.





That all sounds confusing, lol.

 

[maf2k8]

Then you can use your ZAP on your other devices ( that have a adjustable center pin ) like say your, Nemesis!

 

[Cyrus Vap]

Really cool! Don't you need a nut with the bolt and washer to hold it in place? Sorry I'm a bit mechanically declined lol

 

[maf2k8]

Really cool! Don't you need a nut with the bolt and washer to hold it in place? Sorry I'm a bit mechanically declined lol

I used a nut and bolt i had in my shed. No washer was needed though.