This will be very nice for RBA fans...

[BigErn]

Take a look, I like what this company is and has been producing, very slick site also. I wish I could get my hands on a prototype of the puppy 14500 mod. Take a look at this if you use a lot of RBAs:
Turtle | atmizoo vaping modware

 

[PEneoark]

That's actually a damn good idea!

 

[kwalka]

Hey, check this out fellows... set up base - MMVapors

 

[Underwhelmed]

I saw that a while back.

If you don't want to wait for that one-
set up base - MMVapors

 

[Scott_Simpson]

That's actually a damn good idea!

It sure does! Does anyone know that the actual tap and die specifications are for the 510 connection? I saw them somewhere once upon a time and can't find them now ...

 

[st0nedpenguin]

I use...a hand.

 

[been there]

I use a small block of wood with a few small holes in it , aint pretty but gets the job done .

 

[Underwhelmed]

I use a small block of wood with a few small holes in it , aint pretty but gets the job done .

I was thinking, with a nice piece of wood, a 510 wired connection, a small AA battery box, push button and a resistance checker fron madvapes, a bit of solder and some polyurethane you could make a nice rba rebuild stand/resistance checker without spending a bunch of money.

Parts-
http://www.madvapes.com/ohm-meter-display-and-control-board.html
http://www.madvapes.com/prewired-510-battery-connector-sealed-1.html
http://www.madvapes.com/5-blue-button-switch.html
http://www.madvapes.com/bridgeless-510-atomizer-2-ohms.html

 

[bubbadreier]

I made something like this yesterday! Haha

I had an unusable 510 connector that I screwed up on a soldering job. I took a small block of wood and drilled a hole a little smaller than the connector and pushed it in. Flipped over the block and filled the hole with epoxy. I don't have my rebuildable atty yet but when I do I will be ready.

 

[bubbadreier]

I was thinking, with a nice piece of wood, a 510 wired connection, a small AA battery box, push button and a resistance checker fron MadVapes, a bit of solder and some polyurethane you could make a nice RBA rebuild stand/resistance checker without spending a bunch of money.

Parts-
Ohm Meter Display and Control Board
Prewired 510 Battery Connector, Sealed
.5" Blue Button Switch
Black 2xAA Battery Box with On/Off Switch

That is actually not a bad idea! let us know howit turns out if you decide to build it

 

[~Shado~]

If you are energetic...... Ohm Meter Kit

If you are lazy like me..... Cartomizer and Atomizer Ohm Meter

This works great...holds attys good and just a flip of the switch and I know me ohms....

 

[been there]

These are really good ideas and the nice thing about this is not only functional but can be done cheep .

after posting this got to thinking you could also put a connector of some kind on the piece of wood to plug a volt meter into and save a little bit more, this could be made for next to nothing .

 

[Njt07]

Take a look, I like what this company is and has been producing, very slick site also. I wish I could get my hands on a prototype of the puppy 14500 mod. Take a look at this if you use a lot of RBAs:
Turtle | atmizoo vaping modware

I like the squid on their site!