Those that have taken the rotary Dremel to your juice channels

[Jdbaker82]

In clone Kayfun Russians foggers etc.... Did you find more positive or negative results? I am just curious if deepening/widening thinner juice channels just a little bit can help with wicking juice faster or is there a chance of asking for trouble of leaking /gurgling after opening juice channels...

Sent from my SCH-I545 using Xparent Skyblue Tapatalk 2

 

[etchie]

I was hoping for an answer to this as well. I'm particularly concerned because I have an authentic one. I was thinking about getting one of the drill out center pins when they go on sale and I thought with the additional airflow, I maybe going through more juice than usual and I could start getting dry hits if I didn't find a way to get liquid to the coil faster.

 

[vapdivrr]

I have done this on all of my authentic kayfuns and as I remember it seemed to help. initially I only did one and compared it to the ones that weren't done and although it wasn't a major difference, it did seem to make for a juicier vape. I deepened both channels which also made them wider a bit. at the time I had no dremmel and just took a drill bit and used the side of it to deepen them. went thru a bunch of bits and after that went out and bought a dremmel. i wish i would of left one alone to continually compare because now i know the kayfuns inside out and i could of made a better comparison between. i can tell you that i didn't increase that much, maybe i increased depth and width by 20 percent and no ill effects have happened as a result

 

[drmarble]

I have two clones that had totally inadequate channels. Nothing but dry hits. I compared the channels to my clone 3.1 and working russian clone and decided to enlarge them. I didn't go wild. The dry hit stopped and they have worked fine for months.
The necessity of enlarging the clones channels was fairly obvious when comparing them to working devices.

 

[Hoopie]

After I got my authentic KFL+V2, I dremeled the juice channels in all my clones. They looked right but were barely opening in the chamber, also at the bottom it seemed that the channel became very shallow.