Three things that changed for my grand today!!!

[marsos52]

Hi my fellow Reonuts,, I mean Reonauts,

First I ordered two AW 1600 batts so I'm at full spec now, haha . was using sony 1600 and I'm not a total fan of them.
I can really tell the difference between the two batteries.

next I found the button seems to work better with out the Delran cap cover. Seems to better better contact and doesn't lock itself out after a lot of use.

next, I changed my coil making. I usually do 4 wraps with 28 gauge for a .8ohm coil. Today I used 28 gauge but used a thinner rod to make my coils. still got .8 ohms but with 7 wraps. so far this seems a better set-up. vape is thicker and flavor seems better.
only time will tell for sure.

and last but not least, today was my Reo Grands first bath. it wasn't feeding juice to the Reomizer, I tried several things and still not working. So to the bathroom sink it went. after a through rinsing and blow dry. all's as good as new.

just another day in Reo ville

its 5 0'clock somewhere

 

[JC Okie]

Yay, yay, and yay. You might check and see if your feeder tube is a little too long....sometimes it will suction itself to the bottom of the bottle and not feed right. The fix is to either trim it off a little shorter so it can't reach the bottom, or clip a little inverted "V" in it on the bottom so that it can't suction itself to the bottom....or both. I think Rob mentioned once that he was leaving them a little longer these days, so it's something to check. The cleaning is always a good idea, but it should be feeding right regardless.

 

[MamaTried]

Yay, yay, and yay. You might check and see if your feeder tube is a little too long....sometimes it will suction itself to the bottom of the bottle and not feed right. The fix is to either trim it off a little shorter so it can't reach the bottom, or clip a little inverted "V" in it on the bottom so that it can't suction itself to the bottom....or both. I think Rob mentioned once that he was leaving them a little longer these days, so it's something to check. The cleaning is always a good idea, but it should be feeding right regardless.

+1

i did this to two Reos earlier that i hadn't got around to. problem solved...

 

[SeaNap]

+1 for notching a V on the bottom of the feeder tube

 

[Vash]

Yeah tube seemed little longer on my brother in laws new one .Quick trim and good to go !

 

[Raynman]

My inverted V's went into the feed tube before the juice went in the bottle.

 

[marsos52]

I clipped the tube making a "V" shape and it's working well.