Tobeco Stillare question.

[Mrdieter]

So I haven't had the time for looking at specs and what not, but last night I went to tighten down my leads while building my coil. When I tightened the center lead down it spun so know my holes are off center. I can turn it around an fix it but once I tighten the screw it will move on me. Any one have any ideas on if this is going to be an issue? I've been vaping it all day as I'm stuck at work, an it's still working fine as far as I notice. But any advice on keeping this from happening again or tell me my Stillare is on the verge of death would be greatly appreciated.

Thanks tons!

P.s this happened while tightening down 24g wire, if that helps as well.


Sent from my iPhone using Tapatalk

 

[Ryan Kelly]

you might need a new insulator for the center post. it might have twisted loose or got damaged and isn't as taught now. your clone may have come with some extras but if not you can find them on most sites that sell RDAs

 

[Mrdieter]

you might need a new insulator for the center post. it might have twisted loose or got damaged and isn't as taught now. your clone may have come with some extras but if not you can find them on most sites that sell RDAs

That's what I was thinking after I posted this. I haven't changed the insulator before on any of my rda's, any idea on how to do that?

An thanks a lot for your input! Greatly appreciated!


Sent from my iPhone using Tapatalk

 

[Mrdieter]

I'm unable to find any guide on how to go about changing that o-ring on the tobeco Stillare. Any one know if the v2s have the same issue?


Sent from my iPhone using Tapatalk

 

[Mrdieter]

Bump.


Sent from my iPhone using Tapatalk