Triangles - get em quick

[redeyedancer]

hmmm one of mine needs a new insulator maybe I should snag one up or 2

The insulator I use doesn't come with the atomizer

 

[Wickeddeuce]

They go really fast - usually gone in a couple of hours.

well poop... hopefully this time is a change... oh well... if not ill be sure to set 30 or so aside for the next time they are available...

 

[Justice]

The insulator I use doesn't come with the atomizer

OH ok pm incoming boss

 

[Alexander Mundy]

Just got the notification. Triangles are currently in stock. Get-em-while-their-hot.

Triangle Stainless Steel Rebuildable Atomizer

Yea, saw mine at about 4:30 CST and immediately ordered 2 from the job site. Last 2 times I waited till the next day and they were out of stock by then.

 

[thinkingaboutit]

Oh its definitely worth it you get the top cap and all the parts .

Whew. Then I didn't waste my money for once.

 

[r2d2]

Thanks for the pro tip. Ordered a couple.

 

[STLJohnny]

Does anyone use these for taste testing, manually drip and not be concerned about juice dripping back down into the tube?
I would think I would like it for that reason as well as spare parts.

 

[Filthy-Beast]

would only work LP grands as the base has not been milled.

 

[Alexander Mundy]

Got my triangles and in the extra bits package there are small pieces of "SS mesh" to be used for the triangles actual intended purpose.
They are not mesh as I am familiar with but seem to be metal foam.
They aren't ferrous since they are not attracted to a magnet so maybe they are SS?
Anyone know if indeed they are SS?
Might have to experiment with them.

Close up pic:

 

[supertrunker]

Nickel perhaps? there were a few co-ops for that stuff a few months back for carto users.

T

 

[johni]

Terry, I think that is nickel foam. Todd did a You Tube review of it as a wick in a genny.

 

[Alexander Mundy]

Yep, I saw Todd's review of the Nickel and the co-op.
The instructions call it SS, but you know how that goes.
Will have to see what chemical reaction can differentiate on one of them.
If indeed they happen to be SS that would be perfect for my low voltage atty.
SS mesh works but takes many layers to work as the wick part of the equation.
Don't know that I would want to resistance heat Nickel for hybrid coil/wick use.

 

[Alexander Mundy]

Interesting thing.

Took a triangle top and drilled 5 X 0.029" holes horizontal across the coil area when fit on an RM2.

Makes more vapor with same draw resistance as my normal sized single hole without sacrificing flavor or throat hit.