RDA Troll v1 intakes land wrongly

[wwwmarty]

Only thing I don't like about this RDA is that the coils land in a bad position when screwed into my R80, so I get a bit of splatter out of the air vents right onto my chest and shirt. I end up holding the box at a 45 degree angle from what is comfortable -- I'd rather the intakes point left and right rather than front and back.

Of course I can turn the cap so the intakes are correct, but then they're off the coils so don't hit as well as they should. I can't find any way to adjust the base so the coils land where I want them when screwed into the mod. Anything I can do here?

 

[Verb]

510 to 510 adapter, heat sink, or build the coils over to the sides of the deck.

 

[ThaFuzz]

+1^ build offset vertical coils with a smaller diameter. It'll let you move the AFC off to the sides and keep it from spitting so bad. You could also throttle the AFC down a little when you do the verticals and fight spitting even more(assuming you run it wide open)

 

[Izan]

Only thing I don't like about this RDA is that the coils land in a bad position when screwed into my R80, so I get a bit of splatter out of the air vents right onto my chest and shirt. I end up holding the box at a 45 degree angle from what is comfortable -- I'd rather the intakes point left and right rather than front and back.

Of course I can turn the cap so the intakes are correct, but then they're off the coils so don't hit as well as they should. I can't find any way to adjust the base so the coils land where I want them when screwed into the mod. Anything I can do here?

Use a drip tip o-ring as a compressible washer/spacer around the male 510.

Cheers
I

 

[gpjoe]

Go to Kidney Puncher and buy some "mod guards" - 22mm plastic shims that go under your atty.

KP Mod Guard - 5 Pack