unflavored base
- Thread starter Spaggy
- Start date
- th_trl_thread_readers 0
- Status
My freedom smokes?
Never used it but its well known so should be fine
I would scan the DIY forums as every base has its fans and quirks
Never used it but its well known so should be fine
I would scan the DIY forums as every base has its fans and quirks
1 Liter is quite a bit...
Are you planning to stay on 24mg nic for a long time? I would think it is quite strong.
Are you planning to stay on 24mg nic for a long time? I would think it is quite strong.
Np
If i remember right i think mfs is only second to wizard labs popularity wise, so i would use it without thinking about it.
If i remember right i think mfs is only second to wizard labs popularity wise, so i would use it without thinking about it.
I have the MFS 24mg in a 50/50 PG/VG ratio, as well as the 100mg in the same 50/50. I prefer the 100mg because it is possible to make final PG/VG mixes that you may not be able to do with 24mg. But other than that, it is fine base. It is easy to down mix it to lower concentrations, so you will want to pick up some PG and VG for that purpose. You are probably down to ~18-20mg after flavoring, depending on your flavor strength. I've been down mixing mine to final 6-10mg lately.
Hey Spaggy,
download the E-Juice Me Up DIY juice calculator, if you already haven't, and play with numbers.
It has helped me a lot at mixing.
R
download the E-Juice Me Up DIY juice calculator, if you already haven't, and play with numbers.
It has helped me a lot at mixing.
R
I also am ready to start diy juice. Is it wise to start with no nicotine until you get the flavor you are looking for then add it in lower amounts such as 3mg /6mg/12mg or does it change a good flavor that much?
thanks I just downloaded ..........correct me if im wrong this is what I got so I don't need to add any vg or pg cause I got it in 24mg right? https://www.myfreedomsmokes.com/nic...liquid-nicotine-eliquid-vapes-unflavored.html
ok just wanted to make sure Ive tried a local shop diy kit and did ok and wanted to make sure this want straight nic!
if all works out gonna use mfs juice and use my local shop for flavouring cause they are hands down the best ive taste so far ...they have tobacco liquid that I love and cant get away from !
if all works out gonna use mfs juice and use my local shop for flavouring cause they are hands down the best ive taste so far ...they have tobacco liquid that I love and cant get away from !
Last edited:
Congratulations... and you lived!
Get the fastest (smallest gauge number) blunt needles you can find. Depending on your PG/VG ratio, something like a #14 will probably work. If it doesn't then don't use a needle at all. A standard plastic syringe will pull even pure VG without a needle. You may want to get a small beaker, something like a 50ml size in the event your syringe does not fit in your nic bottle's neck. Or use something low rent like a small juice glass
The beakers are nice because of the pour spouts. I've seen needles up to 3" long advertised but they are a little hard to find. The longer the needle the less accurate the measurement since the juice inside the needle is not accounted for, so different size needles are nice to have. Depending if it's more important to get deep into that bottle or accuracy is more important I usually warm my NIC and VG bottles in a sauce pan full of hot tap water. That thins it out quite a bit.
I would suggest poking around the DIY forums for lots of good info.
I used to buy syringes from walgreens with no needles, amazon and wizard labs where i get my juice.
Vape on brother, vape on!
I used to buy syringes from walgreens with no needles, amazon and wizard labs where i get my juice.
Vape on brother, vape on!
- Status
Similar threads
