Update: New Fluid Arrived

Status
Not open for further replies.

IndigoChild

Senior Member
ECF Veteran
May 10, 2014
178
101
Sacramento, California, USA
The new fluid arrived which, if you didn't see my more recent posts in my other threads is 100% PG, not VG. I messed up on transposing what I ordered into my post. The fluids are also 18mg instead of the 36mg I was using which was too spicy. So, the bottom line is that the lower nicotine content and the PG fluid are WAY less harsh! I haven't coughed at all so far :) The fluid isn't as thick though, and the vapor plumes aren't as thick as the 70%VG/30% Distilled H20 36mg, but that's fine with me.

In fact, the thicker, darker fluids were, what I think, what was causing the gurgling and leakage. In just four or five days (and this was also a recent post in one of my threads), the coils were completely toasted! …Nasty, nasty, icky! They were completely brown on the white, fabric part and disintegrating. I had to soak everything but the batteries (obviously), to get the mess cleaned up and then had to replace the coils in both units. I probably won't be using any of the old fluids that were the thick, dark stuff. Just FYI, they were from Mt Baker and were French Vanilla, Dream Tea, Guava, Honeydew, and Pear, although I doubt the flavors matter.

However, I noticed the thicker fluid lasts a LOT longer than the more watery fluid in the 100% PG. The flavors in the new fluids aren't as strong either - I ordered an extra shot of flavor in two of them though and I'm glad I did. The new flavors are Cake (Yellow), Cheesecake, Blueberry, Strawberry, Grappler (a grape-y fruit mix), and Coconut. So far I've only tried the Cheesecake and the Strawberry and they're both really good. Any opinions on my experience so far? Lol. And thanks to everyone once again for all the feedback!
 

IndigoChild

Senior Member
ECF Veteran
May 10, 2014
178
101
Sacramento, California, USA
The VG was a goopy, nasty mess and I don't think I should even put it into my Kanger EVOD units anymore because I'm afraid it might actually ruin the units. There's just something not quite right about what was going on… Not to mention, sticky and staining, too. I just finished a tank I put a few drops in and there was no gurgling, leaking or flooding by the way, either. I will blog the above post...
 

Hijack

Super Member
Verified Member
May 7, 2014
347
201
Bournemouth, U.K
The VG was a goopy, nasty mess and I don't think I should even put it into my Kanger EVOD units anymore because I'm afraid it might actually ruin the units. There's just something not quite right about what was going on… Not to mention, sticky and staining, too. I just finished a tank I put a few drops in and there was no gurgling, leaking or flooding by the way, either. I will blog the above post...

hi Natalie, I just replied on your other thread, but im glad to hear its sorted. keep the tanks topped up, don't let them go below 1/3 full and you should not get the flooding. VG is pretty thick stuff and was probably helping to gunk up the coils in short time. I use a 70/30 PGVG which is quite thin.
 
Status
Not open for further replies.

Users who are viewing this thread