upgrade switch button for nemesis clone?

[Ebertshay]

Hello everyone,
I have a nemesis clone (I think made by H cigar? Got it from vape royalty) and it's just fine, but I'm not too thrilled with the switch button. It gets stuck all the time and drives me nuts. Any recommendations on a good upgraded button I can get? The magnetic ones sound kinda slick but I wonder how well they work... and how fragile they are.. I'd be perfectly happy with just another regular one that's more smooth.
Anyways, I'm gettin a reo soon (and am really excited) but I'd like to keep it around for backup, so a better switch would be swell. Any advice appreciated! Thanks!

 

[Thrasher]

sounds like it just needs to be cleaned and a little noalox added. the magnets just replace the spring, it isnt a complete button replacement.

 

[K_Tech]

Mine's at home right now, so no pics, but it seems to me I get better action out of the switch if it sits closer to the body of the mech. Try turning the center post in a hair at a time and see if that helps...

 

[Heavyrocker]

The orginal Nemmy swith is crunchy also.

 

[crxess]

Switch should be adjusted for a total of about 2mm gap from the lock ring when fully unlocked. This will allow full throw with minimal gap. Fine tune as needed.

Definitely consider cleaning and a bit of noalox for the threading.

 

[ncvapfan]

take it apart and make sure the spring is locked into the groove on the brass housing. Then screw it in to 2mm. Don't lose the pin, my switch is super smooth and has a fairly short throw now