VAMO trouble
- Thread starter dyingisliving
- Start date
- th_trl_thread_readers 0
- Status
No but you might be able to get a 510/ego adapter to screw in and/or some electrically conductive epoxy...
Or switch to eGo threaded clearomizers
Or switch to eGo threaded clearomizers
Is the threading damaged? I love the look of these, I'm wanting to order one but I keep reading people saying the threading is useless.
I bought a 510 ego adapter with the vamo, it didn't thread in so I just used the booty ring for a snug fit to save the threads as long as I could. 
at least I wasn't surprised when it happened. someone needs to make an ego threaded RDA before I weld on a booty ring to my RDA!
at least I wasn't surprised when it happened. someone needs to make an ego threaded RDA before I weld on a booty ring to my RDA!
yes the threading is striped out I never cross threaded it either, however I did drop her a couple times all above 4ft 2 of them on to concrete.
It would be helpful if someone made an eGo to 510 adaptor, but there's only 510 to eGo.
Better yet..sell spare parts for the Vamo...the entire press fit top cap being one of em!
SOMEONE should re-invent the wheel here an ditch the thread idea and make toppers and apv/mods etc attach like air tools! 2cents
I agree. Some type of Quick Disconnect would be nice. I don't see why it can't be done.
Sent from my DROID4 using Tapatalk
could always pop a V2 on head on there
Vamo Body Parts
the connection would have to be near perfect or it could possibly lead to an intermittent connection
Last edited:
I must have the only Vamo3 on ECF that hasn't striped out. I got mine the first of october and use it daily. I switch between 3-4 ProTanks during the day.
The parts from Ecigarette Impressions should mwork.
The parts from Ecigarette Impressions should mwork.
RaceGun59:11730003 said:
Lol. I'm still on my v2 and the threads are still fine. But the plastic piece for the display popped out. I just used a clear piece of tape and taped it back. Ugly, but looks don't bother me.
Lol, you probably do. The threads on my V3 lasted about two months before nothing would thread in. And yes, the replacement top cap from that vendor works like a champ. The threading appears to be MUCH sturdier and better cut than the original.
My V2 is still going strong at 8 months. V2s had some threading issues with the connectors but I am wondering if that didn't get a whole lot worse in the V3s. ANyone heard anything on the V4s or V5s?
I also thought about a non-threaded connect point, the push and twist type found in electronic signal use would be a starting point...
I think its called a BNC connector
Last edited:
Mine is doing fine too..I do make sure I am EXTRA gentle on screwing on the 510 stuff...I got a bunch of eGo threaded clearomizers however...I really like how the positive retention and lack of wobble due to more meat on the threading...which is a solution for the 510 stripped threads...there are quite a few on FT.
- Status
Similar threads
