Vamo V1 seems to misfire when charge drops to 3.8v

[Steve K]

My Vamo V2 Seems to fire fine after the battery has a full charge,But when it drops to around 3.8 v it starts to misfire for some reason I have to push the button 2 or 3 times for it to work,I would have to exclude the center pin issue for as I said it does not happen on a full charge.Any suggestions??

 

[Steve K]

Is this question in the wrong spot??? I asked a question about a vamo in the vamo section and no answer or suggestion 4 days later.

 

[GaryInTexas]

No responses because my V2 or V3 have never done that and I haven't seen any other posts about that issue. It must be something weird with your particular unit. I would only suggest that you verify the actual battery voltage with a multi-meter just to confirm that the battery is not lower than what the Vamo is reading.

 

[Steve K]

No responses because my V2 or V3 have never done that and I haven't seen any other posts about that issue. It must be something weird with your particular unit. I would only suggest that you verify the actual battery voltage with a multi-meter just to confirm that the battery is not lower than what the Vamo is reading.

Thanks gary,I can only suspect the actual batteries but it happens with everyone I have,But It could be the center pin and it just works better when it is at a full charge possibly.I will check it with a multimeter though and see,Btw I am using Efest batteries if it matters.

 

[ElConquistador]

I'm starting to have the same problem with mine, but the battery charge doesn't seem to make any difference. I've noticed if it misfires and I push the button a little harder it goes ahead and fires. I'm wondering if the button contact is getting dirty or something. Anyone know if there's any kind of electronic contact cleaner I could spray into the button area? I don't want to risk taking anything apart.