Some people are having problems with their threads on the Vamo V3 and some aren't I guess.Anyway,I seen it in one thread where people are using 510 extenders and such to solve the problem but are unhappy with how it looks having the tank so far up off the device.Also people are ruining their center pins by screwing their toppers down to far trying to cure the wobble.
Well here is an easy and cheap fix.
eGo Cone Cover for DCTank
I just screwed this onto the cone threading and left it raised slightly above the 510 connection on the Vamo.Screwed my Protank2 down till it tightened against it and all is well.No more wobbly tank,no worries about screwing the tank down too far and ruining the center pin.I dont know if anyone else uses these,I am sure they do,but it gives a much better finished look than the extenders and such.
If you want to hide that tiny gap between the tank and Vamo,just unscrew your top ring on the Vamo till it butts up against the tank.
Well here is an easy and cheap fix.
eGo Cone Cover for DCTank
I just screwed this onto the cone threading and left it raised slightly above the 510 connection on the Vamo.Screwed my Protank2 down till it tightened against it and all is well.No more wobbly tank,no worries about screwing the tank down too far and ruining the center pin.I dont know if anyone else uses these,I am sure they do,but it gives a much better finished look than the extenders and such.
If you want to hide that tiny gap between the tank and Vamo,just unscrew your top ring on the Vamo till it butts up against the tank.
