Vape is not working and is skipping the timer on screen.

Status
Not open for further replies.

Yuri11

Full Member
May 1, 2018
9
8
29
Germany
Hey guys,

I have smok G150 Battery mod and I've stopped using it for a few months (it was working fine before) then after I came back and charged it again, charging it took more time than expected and never got over 95% percent. Then when I tried it, it didn't heat the juice or make sound or anything. The screen is working fine but when I hit the button to vape the timer doesn't count the seconds until when I left my finger off the button the timer skips into how many seconds I was pressing the button. I tried to fiddle with it a bit and I got it to work again after restarting a few times, but then it stopped working again same problem so I changed the coil. And still I can't find a way to make it work again. I tried every settings, and I am sure that the tank is connecting probably since the mod is recognizing it.

I fear that the battery is dead, but it is still new. I used it for couple months only before stopping for a while.
 
  • Like
Reactions: stols001

Yuri11

Full Member
May 1, 2018
9
8
29
Germany
You might try a reset, the hole between the usb connector and the menu buttons is a reset button, use a pin, wire or straightened paper clip to depress the reset for more than 10 seconds.

If that doesn't work time to find a new better power device.


Yeah I tried reset and it didn't work. and I just noticed the Voltage and it says 0.048 so I am guessing the power mod is dead :(
 

Baditude

ECF Guru
ECF Veteran
Apr 8, 2012
30,394
73,076
71
Ridgeway, Ohio
Status
Not open for further replies.

Users who are viewing this thread