I wanted to share my current project with the rest of the group to see if I'd spark some interest in the ECF modders also 
Ok.. So my project started after seeing this
But I wanted to boost the idea a bit.. This had non removable cords/handles.
And the power source was an old laptop PS.
So what I did was turn to the wonders of the WWW and found a quide from WikiHow about turning your PC PS into Lab PS.
Took some time dismantling and testing out that the new PS worked.
Ok after that I started to think about how and where to but my new PartyBox..
So I found Finnish Army gear vendor selling 50'cal ammoboxes.. Grrreeeeaat!
So next step was to think what other parts I'd need in this project..
And as a lazy bugger I decided to use the pre-made knops ofc).
Then.. Needed the volt meters. So yet again bought some RC 1S-6S Lipo Battery Voltage Indicators.
And wanting to keep the handles short as possible yet to go a loooooooong way I got some Black tattoo machine cords for the "old phone" spring cords.
Wanting to make an plug&play I decided to go for the 2 Pin Male & Female Panel Chassis Connector Kit.
Not forgetting the main switch
Now to the crafting part.. I own two Bombshells, so I thought that the diameters of a Bombshell would be suitable.
But they should involve some high end DIY (not Gepetto guality but close).
So I chose Plumwood. I had them soaked for almost two weeks before I got the cleaning part.
-->Time for Teak finish-->
(Yeah I have the connectors ready to go in by now)..
And the final user handles for the Party vape aka VAPESQUADRON are ready for a pic.
The switches I used were 10A 12V so they should go a looooong way.
Ok.. So my project started after seeing this
But I wanted to boost the idea a bit.. This had non removable cords/handles.
And the power source was an old laptop PS.
So what I did was turn to the wonders of the WWW and found a quide from WikiHow about turning your PC PS into Lab PS.
Took some time dismantling and testing out that the new PS worked.
Ok after that I started to think about how and where to but my new PartyBox..
So I found Finnish Army gear vendor selling 50'cal ammoboxes.. Grrreeeeaat!
So next step was to think what other parts I'd need in this project..
And as a lazy bugger I decided to use the pre-made knops ofc).
Then.. Needed the volt meters. So yet again bought some RC 1S-6S Lipo Battery Voltage Indicators.
And wanting to keep the handles short as possible yet to go a loooooooong way I got some Black tattoo machine cords for the "old phone" spring cords.
Wanting to make an plug&play I decided to go for the 2 Pin Male & Female Panel Chassis Connector Kit.
Not forgetting the main switch
Now to the crafting part.. I own two Bombshells, so I thought that the diameters of a Bombshell would be suitable.
But they should involve some high end DIY (not Gepetto guality but close).
So I chose Plumwood. I had them soaked for almost two weeks before I got the cleaning part.
-->Time for Teak finish-->(Yeah I have the connectors ready to go in by now)..
And the final user handles for the Party vape aka VAPESQUADRON are ready for a pic.
The switches I used were 10A 12V so they should go a looooong way.
Last edited:
