Vapeston Maganus & iVP Mini II Setup
- Thread starter Pug
- Start date
- th_trl_thread_readers 0
- Status
WHAT?
Are you trying to take mouth to lung hits with this thing or something?
You should be in the 60-80W range with that tank and coil, doing straight lung hits with the airflow wide open.
Are you trying to take mouth to lung hits with this thing or something?
You should be in the 60-80W range with that tank and coil, doing straight lung hits with the airflow wide open.
Due to me COPD I am trying to go for Mouth to Lung , new at this so any advice would be welcome .
Most if not all of the sub ohm type clearomizers rely on a large amount of airflow to cool the coil & vapor and prevent burning & to draw liquid into the head. (straight or direct lung hits/ inhales)
You can try the .5Ω head and close off the airflow control more, I doubt it will help much but worth a try.
A clearo with a more restricted airflow allows mouth to lung inhales, something like the the aspire nautilus.
You can try the .5Ω head and close off the airflow control more, I doubt it will help much but worth a try.
A clearo with a more restricted airflow allows mouth to lung inhales, something like the the aspire nautilus.
Hhhmmm... That tank is really designed for full lung hits at high wattage. You say "dry tasting." Do you mean like the wick is burning? Or what? No matter what, I wouldn't think you'd be getting dry hits on that rig at 15 watts; more like it wouldn't make a lot of vapor. Maybe that's it. That's not a tank/coil for use low down in Tootle Puffer territory. You might be happier with a Aspire Nautilus and a 1.2 or better coil.
You can't mouth to lung this tank. Your problems won't go away and personally I would buy a Subtank Mini with the 1.5ohm coil.
It will be, you need 50, 60ishw, full air open and vape a little harder, draw on it faster, direct to the lungs. Your problems will go away but again, if you don't feel you can do this then a change of tank is needed I feel.
In that case, it probably is. Put some juice on the wick before assembly, and take a couple pulls without firing the mod before you begin with a new coil.
Its the newer version I hope with the vertical coils, they are much better.
- Status
Similar threads
- Locked
- Locked
