VaporShark rDNA/Plume Veil coil building?

[Crexture]

Hello all!
I'm looking for a build to put in my PlumeVeil that will give me great amounts of dense vapor, as well as some good flavor. I've tried 1.2 dual micros with 28g (which seem to be my favorite), 1.5 dual nanos with 30g, and 1.35 dual macros with 30g.
I was wondering if there's any builds that give you (unarguably) the best vapor production (as far as a dna 30 device goes)

 

[Sarin]

If the DNA 30 has a lower limit with regards to ohms range then it will be somewhere around that area. Clouds aren't all about low resistance though, airflow, surface area of the coils etc play a bit part.

 

[classwife]

Moved to Coil Builds from E-Cigarette Technical - Tips and Tricks

 

[Dissonance]

The best vapor production is going to probably be at the highest resistance you can pump the full 30w into and not hit the voltage cap. Parallel coils are great for this, especially since you have higher gauge wire. Also, raise your coils up a 'lil bit, center them, and don't have any cotton sitting under the coil (Especially on the plumeveil - take advantage of the airflow coming in through the negative posts!).

Honestly tho, you're going to be able to get better clouds off a mech than a DNA30.

 

[CloudKick]

Hello all!
I'm looking for a build to put in my PlumeVeil that will give me great amounts of dense vapor, as well as some good flavor. I've tried 1.2 dual micros with 28g (which seem to be my favorite), 1.5 dual nanos with 30g, and 1.35 dual macros with 30g.
I was wondering if there's any builds that give you (unarguably) the best vapor production (as far as a DNA 30 device goes)

I have a custom PlumeVeil and honestly "great amounts of dense vapor" will only be found around .2 - .5 builds on a mech. Cranking up the voltage high enough on a .8 build should do the trick on a DNA 30 but I can't remember what the regulator caps out at. Still won't be what a mech does though, unless you have the Project Sub-Ohm thinmaN (iPV3 box mod) which can go down to .3 ohms and crank 150 Watts.