Veritas EHPRO Clone, No Flavor. What am I doing wrong? Help!

[Miata GT]

Before I sprung for the real deal I bought the EHPRO clone version of the highly-taughted Veridas rda. I've tried twisted 26 gauge at 0.8ohms and a regular coil from 24 gauge, both single coil. It vapes just fine but the flavor is seriously deficient compared to my other RDAs. I've tried the cap with the hole both facing the coil and going through the hole in the block.

For me it was a PITA to build and a leaky SOB. If I can't figure this one out I may just PIF. Is is there a trick that I'm missing?

 

[State O' Flux]

Try building a single looped wire, dual coil fixture... makes wrapping, and installing much easier. The cap hole should line up with the base hole... then you (can) turn it for your desired air flow.

Wide open with a single coil is a bit too much air... at least for me. The "trick" I use, with 27ga/0.4Ω 9 wrap duals - fit with rayon or cotton... is leave the air hole/fill port wide open, and control air flow with the drip tip ID.

Can't help with leaks... neither my authentic or clones leak, unless I overfill them. ;-)