Hello All
Newbie Here, 1st time post.
Need some help and advice on diluting ejuice. My wife and I have been smoking analogs for 30 years. I was a 2 PAD Regulars and the wife was PAD Lights.
We ordered a variety of 30ml 18mg nic 80PG/20VG from Mt. Baker. Wanted to make sure we had Flavor and Throat Hit the flavor after steeping was great, unfortunately the Throat Hit was too harsh for me, and almost unbearable for my wife.
I've done extensive reading and research till my Head was spinning and my eyes were bleeding, Just like after my first analog smoke 8-o
As I understand it, the PG carries the Flavor and Throat Hit, and the VG carries the Vapor Plume but reduces the flavor and throat hit?
My question is 2 part:
Just for further info for part one, I have a Kanger Evod, 650 MAH, 3.7 volt fixed and 2.4 ohm coil. (trying to keep it simple to start off)
Thanks in advance for any help or advice.
Need some help and advice on diluting ejuice. My wife and I have been smoking analogs for 30 years. I was a 2 PAD Regulars and the wife was PAD Lights.
We ordered a variety of 30ml 18mg nic 80PG/20VG from Mt. Baker. Wanted to make sure we had Flavor and Throat Hit the flavor after steeping was great, unfortunately the Throat Hit was too harsh for me, and almost unbearable for my wife.
I've done extensive reading and research till my Head was spinning and my eyes were bleeding, Just like after my first analog smoke 8-o
As I understand it, the PG carries the Flavor and Throat Hit, and the VG carries the Vapor Plume but reduces the flavor and throat hit?
My question is 2 part:
- If I dilute the ejuice I have with 100% VG to 65PG / 35VG, will that mellow out somewhat the Harsh Throat hit?
And
- I've calculated the VG needed to add to the 30ml to make it 65PG/35VG, (one of the few times my math class has paid off), to make it a pure Volume 65/35. I would have to add approximately 8ml of VG for a total of 38ml. The thing I don't know for sure, if there are a few other properties in the mix, i.e H2O, alcohol, whatever
would I back off on the full 8ml?
Just for further info for part one, I have a Kanger Evod, 650 MAH, 3.7 volt fixed and 2.4 ohm coil. (trying to keep it simple to start off)
Thanks in advance for any help or advice.