I would like to show you how prepere Heater, by ooSTURMoo. On the basis of cartomizer CS 3
First, you need guts to CS3 and prepared a new heater. I prepared a heater on a string from the "peleon.pl" with Kanthal 0.20 x 5
Put the prepared ceramic heater into a cup:
Now take a piece of silver wire (such as Imeo uses to Iatty) bending the tip at an angle of 90 ":
Put the silver wire into the hole in a ceramic cup with kanthal (it will be wire +). This bending of the wire, we will not fall out while twisting with resistance.
Now, pulling the two ends of resistance wire so that heater went inside the ceramic cup. Then, Kanthal (-) bent on a ceramic cup and the Kanthal (+) with silver wire turn together:
ceramic cup put into the housing::
Now we come to a silver wire (+):
At the height of the seal, cut to required length:
We assume positive pin (silver wire is located between the seal and pin):
Screw the power supply and check if everything is ok:
Mount the metal tube so as to fit perfectly into the cavity string:
Put the rest, pour Liquide and driving:
