Vision Eternity SS Mesh

Status
Not open for further replies.

JuniorNA

Ultra Member
ECF Veteran
Feb 2, 2010
1,134
325
44
NJ
Yes I have a quarter inch piece of oxidized mesh in the vision eternity and also in an igo-s rda. It's much easier to clean and it's a cleaner tasting vape -

I used 4 wraps or nichrome 34 for 2 ohms

Give it a Try you won't regret it

Tip
Wrap the wick first - away from the posts then connect completed wick to posts - bend wick to fit and test


ImageUploadedByTapatalk1365998577.414857.jpg
 

TJ2Q

Senior Member
ECF Veteran
Verified Member
Mar 29, 2013
87
63
NE Ohio
Yes I have a quarter inch piece of oxidized mesh in the vision eternity and also in an igo-s rda. It's much easier to clean and it's a cleaner tasting vape -

I used 4 wraps or nichrome 34 for 2 ohms

Give it a Try you won't regret it

Tip
Wrap the wick first - away from the posts then connect completed wick to posts - bend wick to fit and test


View attachment 199633

Awesome! I just did this with my IGO and it works like a charm. So happy. Can you by chance put up a pic of how you did it with your Eternity? I am interested how you position the wick over the air hole but still get it down to the well. Thanks
 

TJ2Q

Senior Member
ECF Veteran
Verified Member
Mar 29, 2013
87
63
NE Ohio
Nevermind about posting the pic of the Eternity setup. I just needed a cup of coffee and about 3 minutes of staring at it.

Ended up making a funnel wick (26mmx42mm then cutting it at an angle to make the well end of the wick thinner). It doesn't draw up the liquid quite as quickly as the regular straws that I make but I am not planning on cranking out the watts on this one either. All in all... it works like a dream.

Junior, you are my new best friend for the day! Thanks for the push in the right direction.
 
Status
Not open for further replies.

Users who are viewing this thread