Vision extreme question

[Sugarnspice]

Just ordered vision extremes-do I need to pre-burn the wicks or just fill and vape ? Also is there a good article or video on how to maintain these for longer life? would the tips and tricks apply to the vision-seems like most of that is geared to the older type with the 3 seal system. Is there anything else to do besides cleaning them? Thanks Michelle

 

[burns_erin]

Biggest things:

1. Make sure the wick slits on the plug seal are actually lined up with the wicks.

2. Any time you adjust out replace the plug seal, make sure the battery is on.

 

[Sugarnspice]

k thanks -so it's just fill and vape? I heard somewhere with ce2s you have to preburn the wick?

 

[MsTick]

Just fill and vape. Really.

 

[harmonic]

preburning ce2 wicks was from long time ago - some of them had manufacturing residue or something on them.
gotvapes solved this problem with their mfg long ago
and i have not heard of a vision needing to be cleaned first - i think most ppl just fill and go
myself included.
otherwise the adjustments and tips and tricks (well most) are pretty much the same as ce2 or fluxomizers
only thing i have been doing to my vision regulars is mod the seals. i take my dremel with a sanding disk and i carefully sand the cutout where you fill it untill it is flat instead of the half round cut out. this makes it look like a seal for a vision micro, and for me it helps eliminate the 'air bubble' that seems to keep the juice from getting past the seal when filling them. of course if you fill with a needle or needle tip bottle you wont have this problem but i found it easier to mod them once instead of needing a syringe to fill them every time
and +1 what Erin said - screw it on a battery before you put it back together - its easy to push the center tube out of the bottom of the connector.
hope this helps some

 

[Sugarnspice]

Thanks a bunch -should be here anyday now can't wait to try them