Vision Spinner 2

Status
Not open for further replies.
I purchased the Vision Spinner 2 yesterday about 5:00 P. M. I used it all night, and most of today... I finally put it on the charger at about 3:30. It is now 10:30 and the light is still red... I first had it on the USB and charging from the lap top, then I put the USB into the outlet plug and plugged it into the wall. It does blink when I put it on the charger about 3 times and turns red... It has been a continuous red now for about 7 hours... I did not let it die all the way, but, I don't understand why it's taking so long... I have it set at 4.3 on the spinner dial.... Is this normal for it to take this long, and if so, I HOPE it's only because it's the first charge... I have it on the 420mA. I am getting really frustrated... I had a eGO c twist, and the battery is now only holding a charge for about 4 hours,( I did drop it into a swimming pool a while back and it was just now starting to act up) ANYWAY, I decided to Upgrade, and purchase the Vision Spinner 2... Can anyone please give me a suggestion, or let me know if this is normal...

Thank You
 

autobiogphnation

Super Member
ECF Veteran
Verified Member
Oct 14, 2013
553
606
Chicago
Don't charge from a computer. Computer USB is not ideal for charging, it will be super slow/long.
My experience with eGo chargers is to not necessarily go by the light on the charger itself. Your spinner II's LED on the switch should be lit up while charging. It should blink when done and then it will be off.
 
I put it on the charger, because it was still allowing me to vape, but, it wasn't as strong as it was, even with turning it all the way up... So, I thought it was getting low... The light on the battery just went off, and it FINALLY turned green...

Thank you everyone for responding, and your advice... I was ready to throw it... LOL
 
Status
Not open for further replies.

Users who are viewing this thread