vision spinner

[Merry57]

My battery isn't firing all the time. Does anybody know what I can do. It's a vision spinner twist.

 

[Merry57]

I have a vision spinner twist. Can you tell me why or what I can do. The battery isn't firing right please help.

 

[Kalaniboi81]

I've never owned one, but a friend of mine has one that I've checked out. If it isn't firing all the time is it firing more than not? If so then i would clean the 510 connection on it really good and give it a full charge overnight ( I know you probably did that already LOL ). If it's barely firing then i would say send it in or get a new one, because all spinners are is just a small internal battery and if it's not firing then 9 times out of 10 the battery is defective. How long have you had it? How often do you vape it?

 

[bluecat]

Most common reason is the thread are dirty - clean with alcohol swab (atty and 510)- be careful not to push center post down. Another reason could be the center post was pushed down.. pull up gently with a wooden toothpick.

 

[daleron]

Welcome Merry, I don't have one of those; I assume you've all ready tried charging?

 

[auxsend]

I used to get this when my tank was screwed on just a tad too tight. I would back it off a turn, and then lightly tighten it up again, and it would be fine again.

Also, like others have said, get in there and make sure it's clean.

 

[Topwater Elvis]

You don't give much info to give a specific suggestion / answer.

Could be the 510 connection is dirty, try cleaning it thoroughly with qtip & rubbing alcohol. Could be the center pin has been pushed down by over tightened the delivery device or charger. When this happen usually they won't fire or intermittently fire. Very gently pry up the center pin a tiny bit.
Maybe the head in the clearo is bad or a chance the head is not snug/tight in the base, change head or tighten head to base.
Maybe the fire button has gone wonky. Does it light up when pressed.
Is it turned on & charged.

 

[Warpigs]

Welcome to ECF!

 

[Merry57]

I've only had it about 4 weeks. It doesn't fire 3/4 of the time. I use it quite a bit a lot lol. Thanks I will try that I just quit smoking 4 weeks ago. So I do still need this.lol

 

[Merry57]

Thanks I'll try anything I think the pin might of gotten pulled down when charging.

 

[Merry57]

Yes I have but I'm going to clean it good and try the pin. Thanks.

 

[Merry57]

OK thanks for all the help.

 

[Merry57]

Yes it lights up sometimes I have to push on it a couple of time.

 

[Merry57]

Thanks you

 

[bluecat]

I have had my Spinners for about 2 years now. 3 of them. They are nice little batteries. As long as you don't need the high amps and watts, they work great.

I was dripping on mine the other night and had a Kayfun on it last night. Looked kinda funny but was a good vape for me.

One thing to do as well for cleaning is to clean the charger as well with an alcohol swab where the 510 connections connect. The liquid can tranfers from the battery to the charger and gunk things up. Of course don't clean it while it is plugged in.

 

[sub4me]

Turn off five clicks, charge it fully, turn on five clicks, and test it. If still not working you may need a new one.

 

[Davey59]

I used to get this when my tank was screwed on just a tad too tight. I would back it off a turn, and then lightly tighten it up again, and it would be fine again.

Also, like others have said, get in there and make sure it's clean.

This ^^^

About the only problem I have ever had with mine. Well if you don't count breaking them or dunking them in my custom holder that also holds HOT coffee. I am getting quite a pile of em. I have a fake 2.5 Kanger Aero that gives some trouble not connecting sometimes. With that one the button will light up normally but does nothing. When some other atty is on too tight it will flash.