Vision V3 Stardust vs. Kanger T3 bottom coil

[Quoiyaien]

Hey guys,

I have been vaping on my 2.4ohm stardust/ego twist combo, and am getting a bit frustrated with it... I cant seem to get the voltage where I want it without it getting a burnt taste... If I take a toot and then another right away, I get a horrible burnt taste... If I want to vape above 3.8v, I have to wait 30+ seconds between toots.... Also, the flavour seems rather muted...

I have been looking at the Kanger T3 clearomizers, and am wondering how they compare in all the important aspects..

The fact that they are bottom coil leads me to belive there wil be no wicking problems, but I like to chain vape my lower nic liquids, and want something that will work without having to rest between toots...

If anyone has any suggestions on how to get the most out of my eGo clearomizers Im all ears.

Cheers!

 

[windozehater]

what i learned the hard way. with each new clearmizer vision v3/vivi nova,kanger t2/m3, bauway, befor filling the tank take off the top silicone cover and metal retainer(this will require a small needle nose or tweezers or removal of the base stem), now put 1 or 2 drops of juice down the center hole (this jump-starts the wicking process) now fill the tank and let set till the wicks become transparent and all will be great, untill you change the coil. if this is not done and your first toot is too soon, the wick will get burnt just enough at the coil site to restrict juice flow and starve the coil forever.
this should be included with each stardust and coil, actually we all should make it our signature.... good luck-vape on

 

[Quoiyaien]

That is probably why my Kanger M3's work so much better... I filled them and they sat for a few hours before I used them... good thing I had to charge my batteries.

 

[Quoiyaien]

I decided to check out the wick on my stardust, and lo and behold, there was a slight charring where the coil was... I pulled the wick through, and trimmed it raptor style so it is only touching the sides of the tank... It is now vaping way better! I have it set at 4.4v and its not missing a beat... Thanks for the tip!!

Cheers!

 

[Cydnie]

What I did was trim just a sliver off of the bottom of the silicone cover. It seemed to be choking the wick, it did the trick, vapes great now.

 

[Nedley]

I've tried the ViVI and the T3. The T3 won out because I liked the flavor better. The Nova gave too much of a straight juice taste which may be fine for non tobacco juices (don't know, haven't tried them) but the T3 gave more of the smoke taste I look for.

Oh yeah. Almost forgot. While I liked the flavor and vapor volume of the T3, initially I was having problems with leakage to the battery post. I think this turned out to be my own fault as I was doing different flavors and only filling about a third of the way up which is almost a guarantee of leakage. Since I've been filling and keeping it filled more completely the leaking has stopped. However I do have to blow out the mouthpiece tube at every refill. When performance drops I disassemble, rinse with hot water, dry burn, rinse again, let it dry and I'm back in business. I do chain vape this thing.

 

[heateris]

I started my clearomizer use with the CE4+/stardust style. Then I got a Evod and never looked back.