Vivi Nova help please

[budynbuick]

This has probably been answered before but couldn't find anything. When I removed the vivi tank I noticed there is a pool of juice on the inside of the threaded post of the Vamo. It is obviously leaking from the bottom of the tank. Should this be happening? If not, is there a fix? Thanks

Keith

 

[Tibby]

Trim the wicks a tiny bit so when you screw on the tank they dont get caught between the tank and the threads. Happened to me.

 

[terry w]

Try not to overfill your nova,as this can cause the problem you are having.

 

[budynbuick]

Thanks. I trimmed the wick & did not overfill. I will keep a closer watch in case I am letting juice run down the side but It just dawned on me if that were the case the juice would be on the outside of the threads (on the Vamo) & not inside. It seems as though it is coming through the threaded part.

Keith

 

[Tibby]

I had thhat issue and it was such a slow seep I coulden't figure out what was going on. If the wick gets tightened between the tank and threads it leaves enough room for a high pg liquid to phantom seep. Allo, overfilling can cause juice to enter in mass through the coil area when on it's side.

 

[budynbuick]

Not over filling, not crossing wick in threads. It is leaking where the coil head screws into the base. It leaks through there down into the drip well on the mod. I have three VN & one of them does not leak with any coil screwed in. The other two leak with any coil screwed into it. Gaskets look good, threads look good. Its bugging me. Ideas? Fix?