ViVi Nova Mini Tank Question

[pcijohn]

Hi I have a couple questions First I just changed my head and now when I use it I notice a little vapor in the tank never seen that before. Second What is the lowest ohms head I can put on using an evo battery. Third The one I took out was a week old I rinsed it under hot water it cleaned pretty good except for a little burn stain where the wick was sitting on the atty. Should I replace that or just slide it over. Also is it like the regular atty's after they dry I used to do a dry burn to clean the coils. Would you still do this and would your remove the wick before dry burn? Thanks

 

[djtonyb]

The wick is silica, you can dry burn it with the wick in place. Rinse, and it should be good as new.

 

[pcijohn]

The wick is silica, you can dry burn it with the wick in place. Rinse, and it should be good as new.

So rinse it let it dry then dry burn and rinse again?

 

[317Vapers]

Just rinse it off, dry the unit and blow it out, then dry burn it pulsing the switch couple seconds at a time until it glows nice and clean. Then you can rinse again after the dry burn but I never do. Turns out just fine!

 

[pcijohn]

Thanks for the answers

what about this?

First I just changed my head and now when I use it I notice a little vapor in the tank never seen that before

Second What is the lowest ohms head I can put on using an evo battery I would like a warmer hit

 

[PONKAW]

Thanks for the answers

what about this?

First I just changed my head and now when I use it I notice a little vapor in the tank

You may have installed the little "cup" in the silicone seal up side down. make sure the flat-side on the little metal cup is down and ridge-side up. also make sure the headtube is straight... sometimes they can be jarred out of place and then can't seal correctly.
Don

 

[ScottP]

Thanks for the answers

what about this?

First I just changed my head and now when I use it I notice a little vapor in the tank never seen that before

Second What is the lowest ohms head I can put on using an evo battery I would like a warmer hit

1. Start inhaling, then push the button, then release the button before you stop inhaling. If you are still holding the button right up to the point you stop inhaling or even after the last bit of vapor will not be pulled out. When I am done vaping for the session I also do one last small inhale without pushing the button at all to make sure I got it all out.

2. The lowest resistance head for the Vivi Nova is the 1.8 Ohm version and that one should work.

 

[Unforeseen]

Moved to Assorted PV Topics - Tanks