Hi,
I just got a Drag X and I find sometimes when taking a hit the power seems to cut in and out for a fraction of second, a couple of times each drag. I can tell by the heat of the vapor (it gets cooler) and changes in consistency of the the sizzling noise. It does this for about 25% of the hits I take.
Is this normal behavior or is there something wrong?
I've got the 0.15 Ohm coil in, on Smart mode at 50W, (and the "P" symbol shows, whatever that means...). Firmware is 1.0.0.0. Battery is full.
Display format is like the attached photo (not mine).
It's weird too - I don't seem to be able to get into the puff interface by pressing +/-, and neither can I set the clock by holding all 3 buttons (it goes to chipset ID instead).
Thanks in advance for any help.
I just got a Drag X and I find sometimes when taking a hit the power seems to cut in and out for a fraction of second, a couple of times each drag. I can tell by the heat of the vapor (it gets cooler) and changes in consistency of the the sizzling noise. It does this for about 25% of the hits I take.
Is this normal behavior or is there something wrong?
I've got the 0.15 Ohm coil in, on Smart mode at 50W, (and the "P" symbol shows, whatever that means...). Firmware is 1.0.0.0. Battery is full.
Display format is like the attached photo (not mine).
It's weird too - I don't seem to be able to get into the puff interface by pressing +/-, and neither can I set the clock by holding all 3 buttons (it goes to chipset ID instead).
Thanks in advance for any help.